Search results
Results from the WOW.Com Content Network
A boost converter or step-up converter is a DC-to-DC converter that increases voltage, while decreasing current, from its input to its output . It is a class of switched-mode power supply (SMPS) containing at least two semiconductors, a diode and a transistor , and at least one energy storage element: a capacitor , inductor , or the two in ...
The milking booster was so-called because it "milked" the healthy cells in the battery to give an extra charge to the faulty one. The motor side of the booster was connected across the whole battery but the generator side was connected only across the faulty cell. During discharge periods the booster supplemented the output of the faulty cell. [1]
A buck converter or step-down converter is a DC-to-DC converter which decreases voltage, while increasing current, from its input to its output . It is a class of switched-mode power supply . Switching converters (such as buck converters) provide much greater power efficiency as DC-to-DC converters than linear regulators , which are simpler ...
This is a switched-mode power supply with a similar circuit configuration to the boost converter and the buck converter. The output voltage is adjustable based on the duty cycle of the switching transistor. One possible drawback of this converter is that the switch does not have a terminal at ground; this complicates the driving circuitry.
DC-to-DC converters are used in portable electronic devices such as cellular phones and laptop computers, which are supplied with power from batteries primarily. Such electronic devices often contain several sub-circuits, each with its own voltage level requirement different from that supplied by the battery or an external supply (sometimes higher or lower than the supply voltage).
Its use of a series capacitor to couple energy from the input to the output allows the circuit to respond more gracefully to a short-circuit output. And it is capable of true shutdown: when the switch S1 is turned off enough, the output ( V 0 ) drops to 0 V, following a fairly hefty transient dump of charge.
Step 3: Attach the battery charger to your vehicle's battery terminals. Always start by attaching the charger's red clamp to the battery's positive terminal and then attaching the black clamp to ...
An electric battery is a source of electric power consisting of one or more electrochemical cells with external connections [1] for powering electrical devices. When a battery is supplying power, its positive terminal is the cathode and its negative terminal is the anode. [2] The terminal marked negative is the source of electrons.