Search results
Results from the WOW.Com Content Network
In WPA2-protected WLANs, secure communication is established through a multi-step process. Initially, devices associate with the Access Point (AP) via an association request. This is followed by a 4-way handshake, a crucial step ensuring both the client and AP have the correct Pre-Shared Key (PSK) without actually transmitting it.
[3] [4] The new standard uses 128-bit encryption in WPA3-Personal mode (192-bit in WPA3-Enterprise) [5] and forward secrecy. [6] The WPA3 standard also replaces the pre-shared key (PSK) exchange with Simultaneous Authentication of Equals as defined in IEEE 802.11-2016 resulting in a more secure initial key exchange in personal mode.
The Wi-Fi Alliance refers to their approved, interoperable implementation of the full 802.11i as WPA2, also called RSN (Robust Security Network). 802.11i makes use of the Advanced Encryption Standard (AES) block cipher, whereas WEP and WPA use the RC4 stream cipher.
wpa_supplicant is a free software implementation of an IEEE 802.11i supplicant for Linux, FreeBSD, NetBSD, QNX, AROS, Microsoft Windows, Solaris, OS/2 (including ArcaOS and eComStation) [2] and Haiku. [3] In addition to being a WPA3 and WPA2 supplicant, it also implements WPA and older wireless LAN security protocols.
WPA2 has been found to have at least one security vulnerability, nicknamed Hole196. The vulnerability uses the WPA2 Group Temporal Key (GTK), which is a shared key among all users of the same BSSID, to launch attacks on other users of the same BSSID. It is named after page 196 of the IEEE 802.11i specification, where the vulnerability is discussed.
In cryptography, a pre-shared key (PSK) is a shared secret which was previously shared between the two parties using some secure channel before it needs to be used. [ 1 ] Key
The recommended solution to WEP security problems is to switch to WPA2. WPA was an intermediate solution for hardware that could not support WPA2. Both WPA and WPA2 are much more secure than WEP. [21] To add support for WPA or WPA2, some old Wi-Fi access points might need to be replaced or have their firmware upgraded.
In addition, the IEEE 802.11 WG noted that the functionality offered by WAPI systems was equivalent to only a small subset of the security offered by WPA2-based systems. The China NB eventually withdrew WAPI in October 2011 (document JTC1/SC6 N15030) and the project was formally cancelled by SC6 in February 2012.