Search results
Results from the WOW.Com Content Network
In WPA2-protected WLANs, secure communication is established through a multi-step process. Initially, devices associate with the Access Point (AP) via an association request. This is followed by a 4-way handshake, a crucial step ensuring both the client and AP have the correct Pre-Shared Key (PSK) without actually transmitting it.
[3] [4] The new standard uses 128-bit encryption in WPA3-Personal mode (192-bit in WPA3-Enterprise) [5] and forward secrecy. [6] The WPA3 standard also replaces the pre-shared key (PSK) exchange with Simultaneous Authentication of Equals as defined in IEEE 802.11-2016 resulting in a more secure initial key exchange in personal mode.
After the PSK or 802.1X authentication, a shared secret key is generated, called the Pairwise Master Key (PMK). In PSK authentication, the PMK is actually the PSK, [ 6 ] which is typically derived from the WiFi password by putting it through a key derivation function that uses SHA-1 as the cryptographic hash function . [ 7 ]
The more secure WPA2 using Advanced Encryption Standard was introduced in 2004 and is supported by most new Wi-Fi devices. WPA2 is fully compatible with WPA. [140] In 2017, a flaw in the WPA2 protocol was discovered, allowing a key replay attack, known as KRACK. [141] [142] A QR code to automate a Wi-Fi connection using WIFI:S:Wikipedia;T:WPA;P ...
A major security flaw was revealed in December 2011 that affects wireless routers with the WPS PIN feature, which most recent models have enabled by default. The flaw allows a remote attacker to recover the WPS PIN in a few hours with a brute-force attack and, with the WPS PIN, the network's WPA/WPA2 pre-shared key (PSK). [3]
WPA2 has been found to have at least one security vulnerability, nicknamed Hole196. The vulnerability uses the WPA2 Group Temporal Key (GTK), which is a shared key among all users of the same BSSID, to launch attacks on other users of the same BSSID. It is named after page 196 of the IEEE 802.11i specification, where the vulnerability is discussed.
The recommended solution to WEP security problems is to switch to WPA2. WPA was an intermediate solution for hardware that could not support WPA2. Both WPA and WPA2 are much more secure than WEP. [21] To add support for WPA or WPA2, some old Wi-Fi access points might need to be replaced or have their firmware upgraded.
Temporal Key Integrity Protocol (TKIP / t iː ˈ k ɪ p /) is a security protocol used in the IEEE 802.11 wireless networking standard. TKIP was designed by the IEEE 802.11i task group and the Wi-Fi Alliance as an interim solution to replace WEP without requiring the replacement of legacy hardware.