Search results
Results from the WOW.Com Content Network
In April 2010, the Wi-Fi Alliance announced the inclusion of additional EAP [30] types to its WPA- and WPA2-Enterprise certification programs. [31] This was to ensure that WPA-Enterprise certified products can interoperate with one another. As of 2010 the certification program includes the following EAP types: EAP-TLS (previously tested)
The WPA profile also provides optional support for the AES-CCMP algorithm that is the preferred algorithm in 802.11i and WPA2. WPA Enterprise provides RADIUS based authentication using 802.1X. WPA Personal uses a pre-shared Shared Key to establish the security using an 8 to 63 character passphrase. The PSK may also be entered as a 64 character ...
The Wi-Fi Alliance refers to their approved, interoperable implementation of the full 802.11i as WPA2, also called RSN (Robust Security Network). 802.11i makes use of the Advanced Encryption Standard (AES) block cipher, whereas WEP and WPA use the RC4 stream cipher.
Wi-Fi Protected Access 2 (WPA2) security, [9] which aligns with IEEE 802.11i. WPA2 is available in two types: WPA2-Personal for consumer use, and WPA2 Enterprise, which adds EAP authentication. Optional: Tests corresponding to IEEE 802.11h and 802.11d. WMM Quality of Service, [10] based upon a subset of IEEE 802.11e.
The Lightweight Extensible Authentication Protocol (LEAP) method was developed by Cisco Systems prior to the IEEE ratification of the 802.11i security standard. [3] Cisco distributed the protocol through the CCX (Cisco Certified Extensions) as part of getting 802.1X and dynamic WEP adoption into the industry in the absence of a standard.
A major security flaw was revealed in December 2011 that affects wireless routers with the WPS PIN feature, which most recent models have enabled by default. The flaw allows a remote attacker to recover the WPS PIN in a few hours with a brute-force attack and, with the WPS PIN, the network's WPA/WPA2 pre-shared key (PSK). [3]
The recommended solution to WEP security problems is to switch to WPA2. WPA was an intermediate solution for hardware that could not support WPA2. Both WPA and WPA2 are much more secure than WEP. [21] To add support for WPA or WPA2, some old Wi-Fi access points might need to be replaced or have their firmware upgraded.
Temporal Key Integrity Protocol (TKIP / t iː ˈ k ɪ p /) is a security protocol used in the IEEE 802.11 wireless networking standard. TKIP was designed by the IEEE 802.11i task group and the Wi-Fi Alliance as an interim solution to replace WEP without requiring the replacement of legacy hardware.