Search results
Results from the WOW.Com Content Network
A fault current limiter (FCL), also known as fault current controller (FCC), [1] is a device which limits the prospective fault current when a fault occurs (e.g. in a power transmission network) without complete disconnection.
Current limiting reactors, once called current limiting reactance coils, were first presented in 1915. [2] The inventor of the current limiting reactance coil was Vern E. Alden who filed the patent on November 20, 1917 with an issue date of September 11, 1923. The original assignee was Westinghouse Electric & Manufacturing Company. [3]
An inrush current limiter is a device or devices combination used to limit inrush current. Passive resistive components such as resistors (with power dissipation drawback), or negative temperature coefficient (NTC) thermistors are simple options while the positive one (PTC) is used to limit max current afterward as the circuit has been operating (with cool-down time drawback on both).
Nationwide data from the U.S. Energy Information Administration [7] shows that Texas's electric prices did rise above the national average immediately after deregulation from 2003 to 2009, but from 2010 to 2015, prices dropped significantly below the national average price, with a total cost of $0.0863 per kWh in Texas in 2015 vs. $0.1042 ...
Texas power prices briefly soar 1,600% as a spring heat wave is expected to drive record demand for energy ... The coming week could see demand topple the current record for May of 71,645 MW set ...
The advantage of a crowbar over a clamp is that the low holding voltage of the crowbar lets it carry higher fault current without dissipating much power (which could otherwise cause overheating). Also, a crowbar is more likely than a clamp to deactivate a device (by blowing a fuse or tripping a breaker), bringing attention to the faulty equipment.
If after the first, swift reclose, the recloser closes onto a fault, it is likely that the fault is a secondary class of fault, vegetation contact or equipment failure. An overcurrent fault would indicate a line to line class fault, which can be confirmed by negative phase sequence overcurrent protection, whereas an earth fault can indicate a ...
In Texas, jaywalking can lead to a fine of up to $200. If a pedestrian is hit while they are jaywalking, they will likely be found at fault for the accident, according to personal injury law firm ...