Search results
Results from the WOW.Com Content Network
As quoted in an online version of: David R. Lide (ed), CRC Handbook of Chemistry and Physics, 84th Edition.CRC Press. Boca Raton, Florida, 2003; Section 4, Properties of the Elements and Inorganic Compounds; Physical Properties of the Rare Earth Metals
In this type the resistance varies with the applied voltage or current. Negative resistance vs positive resistance: If the I–V curve has a positive slope (increasing to the right) throughout, it represents a positive resistance. An I–V curve that is nonmonotonic (having peaks and valleys) represents a device which has negative resistance.
The cold resistance of tungsten-filament lamps is about 1 ⁄ 15 the resistance when operating. For example, a 100-watt, 120-volt lamp has a resistance of 144 ohms when lit, but the cold resistance is much lower (about 9.5 ohms). [76] [b] Since incandescent lamps are resistive loads, simple phase-control TRIAC dimmers can be used to control ...
Electrical resistivity (also called volume resistivity or specific electrical resistance) is a fundamental specific property of a material that measures its electrical resistance or how strongly it resists electric current. A low resistivity indicates a material that readily allows electric current.
For heating, resistance wire must be stable in air when hot. Kanthal FeCrAl alloy forms a protective layer of aluminium oxide (). [1]Aluminium oxide has high thermal conductivity but is an electrical insulator, so special techniques may be required to make good electrical connections.
Also called chordal or DC resistance This corresponds to the usual definition of resistance; the voltage divided by the current R s t a t i c = V I. {\displaystyle R_{\mathrm {static} }={V \over I}.} It is the slope of the line (chord) from the origin through the point on the curve. Static resistance determines the power dissipation in an electrical component. Points on the current–voltage ...
This is an advantage, because sheet resistance of 1 Ω could be taken out of context and misinterpreted as bulk resistance of 1 ohm, whereas sheet resistance of 1 Ω/sq cannot thus be misinterpreted. The reason for the name "ohms per square" is that a square sheet with sheet resistance 10 ohm/square has an actual resistance of 10 ohm ...
Tungsten was discovered in 1781 by Swedish chemist Carl Wilhelm Scheele. Tungsten has the highest melting point of all metals, at 3,410 °C (6,170 °F). Filament of a 200 watt incandescent lightbulb highly magnified. Up to 22% Rhenium is alloyed with tungsten to improve its high temperature strength and corrosion resistance.