Search results
Results from the WOW.Com Content Network
A properly designed crankcase breather will also be designed in a manner that promotes the scavenging effect, or the creation of suction within the crankcase breather to further aid in the removal of blow-by gases. It is this effect that keeps the crankcase at slightly negative pressure when a properly functioning PCV system is in place. [9]
In 1968, the engine had the chrome covers, but without the Chevrolet name, connected to a PCV valve and a chrome 14 in × 3 in (355.6 mm × 76.2 mm) drop-base open-element air cleaner assembly fitted with a crankcase breather on a 780 cu ft/min (22 m 3 /min) vacuum secondary Holley 4-Bbl carburetor. 1969 Corvette and 1970 Z/28 engines were also ...
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
An Emergency Air Breather (EAB) is a device used on board U.S submarines in emergencies when the internal atmosphere is, or potentially is, unsuitable for breathing. It consists of a mask and air hose. [ 1 ]
The main change for the 2012 models was the installation of a different engine from the Ford Duratorq engine range. Ford decided, due to cost reasons, not to modify the 2.4-litre engine introduced in 2007 to meet the upcoming Euro V emissions standards and so the engine was replaced with the ZSD-422 engine, essentially a 2.2-litre variant of ...
A flame arrester during testing A flame arrester made for a 91 cm (36 inch) pipe weighing 10 tons. A flame arrester (also spelled arrestor), deflagration arrester, [1] or flame trap [2] is a device or form of construction that will allow free passage of a gas or gaseous mixture but will interrupt or prevent the passage of flame.
A breather switch, expansion joint, or adjustment switch is an intentional gap in railway tracks to allow for thermal expansion in long sections of otherwise unbroken rail. . They are placed between very long sections of continuous welded rail or at the transition from continuous welded rail to jointed track, and commonly in the vicinity of bridges, viaducts and tunnels where the ...
The pressure vessel is a seamless cylinder normally made of cold-extruded aluminum or forged steel. [5] Filament wound composite cylinders are used in fire fighting breathing apparatus and oxygen first aid equipment because of their low weight, but are rarely used for diving, due to their high positive buoyancy.