Search results
Results from the WOW.Com Content Network
For example, a distance-vector routing protocol may prevent loops by the "split-horizon" rule; that is to say, if a router learns a route from a particular interface it will not re-advertise the route out the same interface.
3.9 – first generally available version for the ASR 9000 router series; 5.0 – first generally available version for the NCS6000 series, which is based upon a Linux kernel instead of QNX, and was released in September 2013 [5] 6.1.1 - Introduces support for the 64-bit Linux-based IOS XR operating system on ASR 9000 series [6]
Now a client on router E wants to talk to a client on router A. That means a route between router A and router E must be available. This route is calculated as follows: The immediate neighbours of router E are router C and router D. DUAL in router E asks for the reported distance (RD) from routers C and D respectively to router A.
C (1 bit) Checksum bit. Set to 1 if a checksum is present. R (1 bit) Routing Bit. Set to 1 if Routing and Offset information are present. K (1 bit) Key bit. Set to 1 if a key is present. S (1 bit) Sequence number bit. Set to 1 if a sequence number is present. s (1 bit) Strict source route bit. Recur (3 bits) Recursion control bits. Flags (5 bits)
IP forwarding algorithms in most routing software determine a route through a shortest path algorithm. In routers, packets arriving at an interface are examined for source and destination addressing and queued to the appropriate outgoing interface according to their destination address and a set of rules and performance metrics.
Classless Inter-Domain Routing (CIDR / ˈ s aɪ d ər, ˈ s ɪ-/) is a method for allocating IP addresses for IP routing. The Internet Engineering Task Force introduced CIDR in 1993 to replace the previous classful network addressing architecture on the Internet .
Carrier Routing System (CRS) is a modular and distributed core router developed by Cisco Systems Inc that enables service providers to deliver data, voice, and video services over a scalable IP Next-Generation Network (NGN) infrastructure. In a network topology, these routers are generally positioned in the core or edge of a service provider ...
There is a difference between a "relay router" and a "border router" (also known as a "6to4 border router"). A 6to4 border router is an IPv6 router supporting a 6to4 pseudo-interface. It is normally the border router between an IPv6 site and a wide-area IPv4 network, where the IPv6 site uses 2002:: / 16 co-related to the IPv4 address used later on.