enow.com Web Search

  1. Ads

    related to: metric torque chart bolt size diameter mm to cm width standard

Search results

  1. Results from the WOW.Com Content Network
  2. ISO metric screw thread - Wikipedia

    en.wikipedia.org/wiki/ISO_metric_screw_thread

    Below are some common spanner sizes for metric screw threads. Hexagonal (generally abbreviated to "hex") head widths (width across flats, spanner size) are for DIN 934 hex nuts and hex head bolts. Other (usually smaller) sizes may occur to reduce weight or cost, including the small series flange bolts defined in ISO 4162 which typically have ...

  3. British Association screw threads - Wikipedia

    en.wikipedia.org/wiki/British_Association_screw...

    The major diameter is given by 6p 1.2, [4]: 12 rounded to two significant figures in mm and the hex head size (across the flats) is 1.75 times the major diameter. BA sizes are specified by the following British Standards: BS 57:1951 — B.A. screws, bolts and nuts

  4. Width across flats - Wikipedia

    en.wikipedia.org/wiki/Width_across_flats

    A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

  5. Screw thread - Wikipedia

    en.wikipedia.org/wiki/Screw_thread

    Thread limit or pitch diameter limit is a standard used for classifying the tolerance of the thread pitch diameter for taps. For imperial, H or L limits are used which designate how many units of 0.0005 inch over or undersized the pitch diameter is from its basic value, respectively.

  6. ISO 898 - Wikipedia

    en.wikipedia.org/wiki/ISO_898

    It specifically applies to fasteners that have an ISO metric screw thread as defined in ISO 68-1. The properties are defined for M1.6-39 with coarse threads and M8-39 with fine threads. The diameter and pitch combinations must adhere to ISO 261 and ISO 262 and the thread tolerances must adhere to ISO 965 parts 1, 2, and 4. [2]

  7. List of thread standards - Wikipedia

    en.wikipedia.org/wiki/List_of_thread_standards

    ISO general purpose metric screw threads—General plan: V Thread Form: M6x1 ISO 262:1998: ISO general purpose metric screw threads—Selected sizes for screws, bolts and nuts: V Thread Form ISO 724:1993: ISO general-purpose metric screw threads—Basic dimensions: V Thread Form ISO 725:2009: ISO inch screw threads—Basic dimensions: V Thread ...

  8. British Standard Whitworth - Wikipedia

    en.wikipedia.org/wiki/British_Standard_Whitworth

    British Standard Whitworth (BSW) is an imperial-unit-based screw thread standard, devised and specified by Joseph Whitworth in 1841 and later adopted as a British Standard. It was the world's first national screw thread standard, and is the basis for many other standards, such as BSF , BSP , BSCon , and BSCopper .

  9. ISO 965 - Wikipedia

    en.wikipedia.org/wiki/ISO_965

    ISO 965 (ISO general purpose metric screw thread—tolerances) is an International Organization for Standardization (ISO) standard for metric screw thread tolerances. [1] It specifies the basic profile for ISO general purpose metric screw threads (M) conforming to ISO 261. [2] The tolerance system refers to the basic profile in accordance with ...

  1. Ads

    related to: metric torque chart bolt size diameter mm to cm width standard