Search results
Results from the WOW.Com Content Network
It is also possible to declare an area both totally stubby and not-so-stubby, which means that the area will receive only the default route from area 0.0.0.0, but can also contain an autonomous system boundary router (ASBR) that accepts external routing information and injects it into the local area, and from the local area into area 0.0.0.0.
The address 127.0.0.1 is the standard address for IPv4 loopback traffic; the rest are not supported by all operating systems. However, they can be used to set up multiple server applications on the host, all listening on the same port number. In the IPv6 addressing architecture [3] there is only a single address assigned for loopback: ::1. The ...
The range of port numbers from 1024 to 49151 (2 10 to 2 15 + 2 14 − 1) are the registered ports. They are assigned by IANA for specific service upon application by a requesting entity. [ 2 ] On most systems, registered ports can be used without superuser privileges.
The Internet Engineering Task Force (IETF) has reserved the IPv4 address block 169.254.0.0 / 16 (169.254.0.0 – 169.254.255.255) for link-local addressing. [1] The entire range may be used for this purpose, except for the first 256 and last 256 addresses (169.254.0.0 / 24 and 169.254.255.0 / 24), which are reserved for future use and must not be selected by a host using this dynamic ...
Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255
Newer versions allow selection of additional policies based on IP addresses (layer2+3) and TCP/UDP port numbers (layer3+4). This selects the same NIC slave for each destination MAC address, IP address, or IP address and port combination, respectively.
Reverse-path forwarding (RPF) is a technique used in modern routers for the purposes of ensuring loop-free forwarding of multicast packets in multicast routing and to help prevent IP address spoofing in unicast routing.
The default TCP Maximum Segment Size is for IPv4 is 536. For IPv6 it is 1220. [1]: §3.7.1 Where a host wishes to set the maximum segment size to a value other than the default, the maximum segment size is specified as a TCP option, initially in the TCP SYN packet during the TCP handshake. The value cannot be changed after the connection is ...