Search results
Results from the WOW.Com Content Network
The Mark 7 gun was a built-up gun and was constructed of liner, tube, jacket, three hoops, two locking rings, tube and liner locking ring, yoke ring and screw box liner. Some components were autofretted. Typical of United States naval weapons built in the 1940s, the bore was chromium-plated for longer barrel life.
In most cases, it is not practical to fix a barrel whose bore is worn out, poorly or unsuitably rifled, or the wrong bore diameter; the primary exception to that is rimfire barrels, which can be inexpensively bored out and re-lined with a commercial barrel liner. [36] If the barrel is unsuitable and relining is not an option, then an ...
The 16-inch Mark 2 was 50 calibers long, with a liner, an A tube, jacket and seven hoops with four hoop locking rings and a screw box liner. The Mod 0 used an increasing twist in the rifling while the Mod 1 used a uniform twist and a different groove pattern. The Mark 3 was the same as the Mark 2 but used a one-step conical liner.
Burning powder gases melt part of the bore each time a gun is fired. This melted metal is oxidized or blown out of the muzzle until the barrel is eroded to the extent shell dispersion becomes unacceptable. After firing several hundred shells, a gun may be reconditioned by boring out the interior and inserting a new liner as the interior cylinder.
Conventional eight groove rifling on the left, and octagonal polygonal rifling on the right. Polygonal rifling (/ p ə ˈ l ɪ ɡ ə n əl / pə-LIG-ə-nəl) is a type of gun barrel rifling where the traditional sharp-edged "lands and grooves" are replaced by less pronounced "hills and valleys", so the barrel bore has a polygonal (usually hexagonal or octagonal) cross-sectional profile.
A muzzle brake or recoil compensator is a device connected to, or a feature integral (ported barrel) to the construction of, the muzzle or barrel of a firearm or cannon that is intended to redirect a portion of propellant gases to counter recoil and unwanted muzzle rise. [1]
A chamber reamer is a specific type of fluted reamer used by gunsmiths and firearms manufacturers to cut the chamber of a handgun, rifle, or shotgun.The chamber reamer is inserted into the bore of a barrel and held stationary while the barrel is turned around it (typically by means of a lathe).
The infantry rifle model featured a 32 5 ⁄ 8-inch (829 mm) barrel, while the cavalry carbine used a 22-inch (560 mm) barrel. It was superseded by an improved model, the Springfield Model 1884 , also in .45-70 caliber .