Search results
Results from the WOW.Com Content Network
Code Composer Studio (CCStudio or CCS) is an integrated development environment for developing applications for Texas Instruments embedded processors.. Texas Instruments embedded processors include TMS320 DSPs, OMAP system-on-a-chip, DaVinci system-on-a-chip, Sitara applications processors, Hercules microcontrollers, Simplelink MCUs (MSP432 and other Wireless connectivity [3] microcontrollers ...
On the left the larger chip version, on the right a small version in USB format. The MSP430 is a mixed-signal microcontroller family from Texas Instruments, first introduced on 14 February 1992. [1] Built around a 16-bit CPU, the MSP430 was designed for low power consumption, [2] embedded applications and low cost.
It is based on a 32-bit ARM Cortex-M4F CPU, and extends their 16-bit MSP430 line, with a larger address space for code and data, and faster integer and floating point calculation than the MSP430. Like the MSP430, it has a number of built-in peripheral devices, and is designed for low power requirements. In 2021, TI confirmed that the MSP432 has ...
Spy-Bi-Wire is a serialized JTAG protocol developed by Texas Instruments for their MSP430 microcontrollers.. To avoid dedicating four pins as required by the general JTAG interface, the Spy-Bi-Wire protocol only uses two: one for bidirectional data, and one for the clock signal.
In computer science, gang scheduling is a scheduling algorithm for parallel systems that schedules related threads or processes to run simultaneously on different processors. Usually these will be threads all belonging to the same process, but they may also be from different processes, where the processes could have a producer-consumer ...
Data is transferred from the programmer to the device as signals via connecting pins. Some devices have a serial interface [9]: 232, pdf3 for receiving data (including JTAG interface). [4]: 642, pdf15 Other devices communicate on parallel pins, followed by a programming pulse with a higher voltage for programming the data into the device.
Around 1987, Data I/O introduced the first of the 'Uni-family' programmers in the form of the 'Uni-site.' This was their first engineering programmer to feature software-programmable pin drivers, a technology that allows any pin of the device socket to be configured, through software, for power, ground, or nearly any type of programming waveform.
Bit banging is a term of art that describes a method of digital data transmission as using general-purpose input/output (GPIO) instead of computer hardware that is intended specifically for data communication.' [1] Controlling software is responsible for satisfying protocol requirements including timing which can be challenging due to limited host system resources and competing demands on the ...