Search results
Results from the WOW.Com Content Network
Some voltage-regulator tubes contained small amounts of radionuclides to produce a more reliable ionization. [1] The Corona VR tube is a high-voltage version that is filled with hydrogen at close to atmospheric pressure, and is designed for voltages ranging from 400 V to 30 kV at tens of microamperes.
Emerson Electric office in Markham, Ontario. Emerson Electric Co. is an American multinational corporation headquartered in St. Louis, Missouri. [2] [3] [4] The Fortune 500 company delivers a range of engineering services, manufactures industrial automation equipment, climate control systems, and precision measurement instruments, and provides software engineering solutions for industrial ...
Series regulators are the more common form; they are more efficient than shunt designs. The series regulator works by providing a path from the supply voltage to the load through a variable resistance, usually a transistor (in this role it is usually termed the series pass transistor); it is in the "top half" of the voltage divider - the bottom half being the load.
The unit here is %/V. For example, In the ABLIC Inc. S1206-series regulator device the typical line regulation is expressed as 0.05%/V which means that the change in the output with respect to change in the input of the regulator device is 0.05%, when the output of the device is set at 1V.
Low-dropout (LDO) regulators operate similarly to all linear voltage regulators.The main difference between LDO and non-LDO regulators is their schematic topology.Instead of an emitter follower topology, low-dropout regulators consist of an open collector or open drain topology, where the transistor may be easily driven into saturation with the voltages available to the regulator.
Regulators can be designed to control anything from gases or fluids, to light or electricity. Speed can be regulated by electronic, mechanical, or electro-mechanical means. Such instances include; Electronic regulators as used in modern railway sets where the voltage is raised or lowered to control the speed of the engine
A voltage regulator module (VRM), sometimes called processor power module (PPM), is a buck converter that provides the microprocessor and chipset the appropriate supply voltage, converting +3.3 V, +5 V or +12 V to lower voltages required by the devices, allowing devices with different supply voltages be mounted on the same motherboard.
A shunt charge controller or shunt regulator diverts excess electricity to an auxiliary or "shunt" load, such as an electric water heater, when batteries are full. [ 7 ] Simple charge controllers stop charging a battery when they exceed a set high voltage level, and re-enable charging when battery voltage drops back below that level.