Search results
Results from the WOW.Com Content Network
This is a list of interface bit rates, is a measure of information transfer rates, or digital bandwidth capacity, at which digital interfaces in a computer or network can communicate over various kinds of buses and channels.
80,000,000 bits – In 1985 a 10 MB harddisk cost US$710, [5] equivalent to $2,011 in 2023. 98,304,000 bits – capacity of a high-resolution computer monitor as of 2011, 2560 × 1600 pixels, 24 bpp 50 – 100 megabits – amount of information in a typical phone book
114 minutes of uncompressed CD-quality audio at 1.4 Mbit/s is approximately 1 GB. A single-layer DVD+R disc can hold about 4.7 GB. A dual-layered DVD+R disc can hold about 8.5 GB. A single-layer Blu-ray can hold about 25 GB. The largest Nintendo Switch cartridge available on the market holds about 32 GB. A dual-layered Blu-ray can hold about 50 GB.
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
In telecommunications and computing, bit rate (bitrate or as a variable R) is the number of bits that are conveyed or processed per unit of time. [1]The bit rate is expressed in the unit bit per second (symbol: bit/s), often in conjunction with an SI prefix such as kilo (1 kbit/s = 1,000 bit/s), mega (1 Mbit/s = 1,000 kbit/s), giga (1 Gbit/s = 1,000 Mbit/s) or tera (1 Tbit/s = 1,000 Gbit/s). [2]
In this convention, one thousand and twenty-four megabytes (1024 MB) is equal to one gigabyte (1 GB), where 1 GB is 1024 3 bytes (i.e., 1 GiB). Mixed 1 MB = 1 024 000 bytes (= 1000×1024 B) is the definition used to describe the formatted capacity of the 1.44 MB 3.5-inch HD floppy disk , which actually has a capacity of 1 474 560 bytes .
For Blu-ray discs, 1× speed is defined as 36 megabits per second (Mbit/s), which is equal to 4.5 megabytes per second (MB/s). [7] However, as the minimum required data transfer rate for Blu-ray movie discs is 54 Mbit/s, the minimum speed for a Blu-ray drive intended for commercial movie playback should be 2×.
The naming convention for DDR, DDR2 and DDR3 modules specifies either a maximum speed (e.g., DDR2-800) or a maximum bandwidth (e.g., PC2-6400). The speed rating (800) is not the maximum clock speed, but twice that (because of the doubled data rate). The specified bandwidth (6400) is the maximum megabytes transferred per second using a 64-bit width.