enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Woodworking vise - Wikipedia

   en.wikipedia.org/wiki/Woodworking_vise

   The traditional tail vise uses one large screw, either wooden or metal. It is made in the form of a frame, with the back part of the frame fitting under the bench, and the movement of that frame located and restrained by a complex system of sliding tongues and grooves, and runners, such that smooth left and right movements of the frame are ...

3. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   This second top plate usually laps the first plate at the corners and partition intersections and, when nailed in place, provides an additional tie to the framed walls. Where the second top plate does not lap the plate immediately underneath at corner and partition intersections, these may be tied with 0.036 in (0.91 mm) galvanized steel plates ...

4. Rotary table - Wikipedia

   en.wikipedia.org/wiki/Rotary_table

   Rotary tables are most commonly mounted "flat", with the table rotating around a vertical axis, in the same plane as the cutter of a vertical milling machine.An alternate setup is to mount the rotary table on its end (or mount it "flat" on a 90° angle plate), so that it rotates about a horizontal axis.

5. Fixture (tool) - Wikipedia

   en.wikipedia.org/wiki/Fixture_(tool)

   A common type of fixture, used in materials tensile testing (Grip-Engineering). A fixture is a work-holding or support device used in the manufacturing industry. [1] [2] Fixtures are used to securely locate (position in a specific location or orientation) and support the work, ensuring that all parts produced using the fixture will maintain conformity and interchangeability.

6. Shaper - Wikipedia

   en.wikipedia.org/wiki/Shaper

   The ram slides back and forth above the work. At the front end of the ram is a vertical tool slide that may be adjusted to either side of the vertical plane along the stroke axis. This tool-slide holds the clapper box and tool post, from which the tool can be positioned to cut a straight, flat surface on the top of the workpiece. The tool-slide ...

7. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   Two pin chucks. The top one is assembled, the lower one shows the body and nose cap assembled with the collet piece below it. A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is ...