Search results
Results from the WOW.Com Content Network
A common example is polyethylene sheeting laid under a concrete slab to prevent the concrete from gaining moisture through capillary action. [5] A DPM may be used for the DPC. Integral damp proofing in concrete involves adding materials to the concrete mix to make the concrete itself impermeable. [4]
This process may occur in three different approaches, however the basic method is the same in each: In situ: Formwork construction and pouring of concrete occur on site, then the slab is assembled (if required). [4] Precast: The slabs are made somewhere else and then brought to the site and assembled. [4]
The dampness results in vaporization where water vapor is transmitted into the building's interiors. Water vapor may enter the building through supply air ducts in building slabs and circulated by warm forced air. Water vapor can also enter a building through leaky return air ducts in homes with crawlspaces. [4]: 185–187
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
A drip chamber, also known as drip bulb, is a device used to allow gas (such as air) to rise out from a fluid so that it is not passed downstream. It is commonly employed in delivery systems of intravenous therapy and acts to prevent air embolism. [1] [2] The use of a drip chamber also allows an estimate of the rate at which fluid is administered.
In practice, creep during drying is inseparable from shrinkage. The rate of creep increases with the rate of change of pore humidity (i.e., relative vapor pressure in the pores). For small specimen thickness, the creep during drying greatly exceeds the sum of the drying shrinkage at no load and the creep of a loaded sealed specimen (Fig. 1 bottom).
Customers who purchased Deep River brand potato chips labeled “Non-GMO Ingredients” may be eligible for a cash payment from a class action settlement.
The test is carried out using a metal mould in the shape of a conical frustum known as a slump cone or Abrams cone, that is open at both ends and has attached handles.The tool typically has an internal diameter of 100 millimetres (3.9 in) at the top and of 200 millimetres (7.9 in) at the bottom with a height of 305 millimetres (12.0 in).The cone is placed on a hard non-absorbent surface.