Search results
Results from the WOW.Com Content Network
Asynchronous serial communication is a form of serial communication in which the communicating endpoints' interfaces are not continuously synchronized by a common clock signal. Instead of a common synchronization signal, the data stream contains synchronization information in form of start and stop signals, before and after each unit of ...
The USART's synchronous capabilities were primarily intended to support synchronous protocols like IBM's synchronous transmit-receive (STR), binary synchronous communications (BSC), synchronous data link control (SDLC), and the ISO-standard high-level data link control (HDLC) synchronous link-layer protocols, which were used with synchronous voice-frequency modems.
Modern high speed serial interfaces such as PCIe [2] [3] [4] send data several bits at a time using modulation/encoding techniques such as PAM4 which groups 2 bits at a time into a single symbol, and several symbols are still sent one at the time. This replaces PAM2 or non return to zero (NRZ) which only sends one bit at a time, or in other ...
Management Data Input/Output (MDIO), also known as Serial Management Interface (SMI) or Media Independent Interface Management (MIIM), is a serial bus defined for the Ethernet family of IEEE 802.3 standards for the Media Independent Interface, or MII. The MII connects media access control (MAC) devices with Ethernet physical layer (PHY ...
At the destination, a second UART re-assembles the bits into complete bytes. Each UART contains a shift register, which is the fundamental method of conversion between serial and parallel forms. Serial transmission of digital information (bits) through a single wire or other medium is less costly than parallel transmission through multiple wires.
These blocks convert data between serial data and parallel interfaces in each direction. The term "SerDes" generically refers to interfaces used in various technologies and applications. The primary use of a SerDes is to provide data transmission over a single line or a differential pair in order to minimize the number of I/O pins and ...
The individual signals on a serial port are unidirectional and when connecting two devices, the outputs of one device must be connected to the inputs of the other. Devices are divided into two categories: data terminal equipment (DTE) and data circuit-terminating equipment (DCE). A line that is an output on a DTE device is an input on a DCE ...
The Arduino Uno is an open-source microcontroller board based on the Microchip ATmega328P microcontroller (MCU) and developed by Arduino.cc and initially released in 2010. [2] [3] The microcontroller board is equipped with sets of digital and analog input/output (I/O) pins that may be interfaced to various expansion boards (shields) and other circuits. [1]