Search results
Results from the WOW.Com Content Network
The fluxgate magnetometer (FGM) is similar to previous instruments flown on spacecraft like the Voyagers, Magsat, Active Magnetospheric Particle Tracer Explorers, Mars Global Surveyor, etc. [10] This style of FGM uses twin wide-range, triaxial flux gate sensors mounted far away from the spacecraft body in which the magnetic flux is periodically switched (hence the ame flux-gate). [10]
Schematic of the Birkeland or Field-Aligned Currents and the ionospheric current systems they connect to, Pedersen and Hall currents. [1]A Birkeland current (also known as field-aligned current, FAC) is a set of electrical currents that flow along geomagnetic field lines connecting the Earth's magnetosphere to the Earth's high latitude ionosphere.
Fluxgate sensors or saturable inductor current sensors work on the same measurement principle as Hall-effect-based current sensors: the magnetic field created by the primary current to be measured is detected by a specific sensing element. The design of the saturable inductor current sensor is similar to that of a closed-loop Hall-effect ...
8-bit AVR XMEGA devices via the PDI 2-wire interface; 8-bit megaAVR and tinyAVR devices via SPI for all with OCD (on-chip debugger) support; 8-bit tinyAVR microcontrollers with TPI support; 32-bit SAM Arm Cortex-M based microcontrollers via SWD; Target operating voltage ranges of 1.62V to 5.5V are supported as well as the following clock ranges:
[8] [7]: 25 The connection between the fluid and magnetic field fixes the topology of the magnetic field in the fluid—for example, if a set of magnetic field lines are tied into a knot, then they will remain so as long as the fluid has negligible resistivity. This difficulty in reconnecting magnetic field lines makes it possible to store ...
The differential change in the amplitude of the resonating shuttle shows the strength of the external magnetic field. The sensitivity of the sensor is determined in static mode to be 0.034 μm/mT when a current of 10 mA passes through the shuttle, while it is found to be higher at resonance with a value of 1.35 μm/mT at 8 mA current.
The Atmel 8-bit AVR RISC-based microcontroller combines 32 KB ISP flash memory with read-while-write capabilities, 1 KB EEPROM, 2 KB SRAM, 23 general-purpose I/O lines, 32 general-purpose working registers, 3 flexible timer/counters with compare modes, internal and external interrupts, serial programmable USART, a byte-oriented 2-wire serial ...
The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus/I 2 C or 1-Wire.. In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware sensors framework [3] since OpenBSD 3.9 (2006), [4] [5]: §6.1 which has also ...