enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   An ASME B18.2.1 compliant cap screw has somewhat tighter tolerances than a hex bolt for the head height and the shank length. The nature of the tolerance difference allows an ASME B18.2.1 hex cap screw to always fit where a hex bolt is installed but a hex bolt could be slightly too large to be used where a hex cap screw is designed in. Fine ...

3. List of thread standards - Wikipedia

   en.wikipedia.org/wiki/List_of_thread_standards

   A screw thread, often shortened to thread, is a helical structure used to convert between rotational and linear movement or force. A screw thread is an inclined plane wrapped around a cylinder or cone in the form of a helix, with the former being called a straight thread and the latter called a tapered thread.

4. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Sex bolt: Barrel nut, barrel bolt, binding barrel, Chicago screw, post and screw or connector bolt Has a barrel-shaped flange and protruding boss that is internally threaded Split nut: Split lengthwise into two pieces (opposed halves) so that its female thread may be opened and closed over the male thread of a bolt or leadscrew Sleeve nut ...

5. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...

6. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   Even though #14 and #16 screws are still available, they are not as common as sizes #0 through #12. [citation needed] Sometimes "special" diameter and pitch combinations (UNS) are used, for example a 0.619 in (15.7 mm) major diameter with 20 threads per inch. UNS threads are rarely used for bolts, but rather on nuts, tapped holes, and threaded ODs.

7. Robertson screw - Wikipedia

   en.wikipedia.org/wiki/Robertson_screw

   Robertson screwdrivers are easy to use one-handed, because the tapered socket tends to retain the screw, even if it is shaken. [3]: 85–86 They also allow the use of angled screwdrivers and trim-head screws. The socket-headed Robertson screws are self-centering and reduce cam out. They also stop a power tool when set, and can be more easily ...