enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   Faucet is the most common term in the US, similar in use to "tap" in British English, e.g. "water faucet" (although the term "tap" is also used in the US). Spigot is used by professionals in the trade (such as plumbers), and typically refers to an outdoor fixture.

3. Plug (sanitation) - Wikipedia

   en.wikipedia.org/wiki/Plug_(sanitation)

   The insertion of a plug into a drainage outlet allows the container to be filled with water or other fluids. In contrast to screw on caps, plugs are pushed into the hole and are not put over the hole. Plugs are most commonly encountered in the bathroom or kitchen, for use in bathtubs, wash basins or sinks. [1]

4. Faucet aerator - Wikipedia

   en.wikipedia.org/wiki/Faucet_aerator

   When an aerator is added to the faucet (or fluid stream), there is a region of high pressure created behind the aerator. Because of the higher pressure behind the aerator and the low pressure in front of it (outside the faucet), due to Bernoulli's principle there is an increase in velocity of the fluid flow.

5. We’ve Found 100 Products That Pandas Keep Coming Back ... - AOL

   www.aol.com/panda-hall-fame-100-products...

   Cleaned up a lot of clutter of plugs where I have my labtop and screens connected. The USB and C outlets really mixed well. Originally ordered 2 units and just ordered an additional one for my office.

6. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   These sizing schemes allow for universal adaptation of transitional fittings. For instance, 1/2" PeX tubing is the same size as 1/2" copper tubing. 1/2" PVC on the other hand is not the same size as 1/2" tubing, and therefore requires either a threaded male or female adapter to connect them.

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   In use, the spigot of one segment was placed into the socket of the preceding one, and a ring of oakum was forced down into the joint with a caulking iron. Then the remainder of the space in the hub was filled up. Ideally, this would be done by pouring molten lead, allowing it to set, and hammering it tightly with a caulking tool.