Search results
Results from the WOW.Com Content Network
Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.
Alfred M. Moen (27 December 1916 – 17 April 2001) was an American inventor and founder of Moen Incorporated.He invented the single-handed mixing faucet.In 1959 Fortune magazine listed the Moen "one-handle mixing faucet", along with inventions such as Henry Ford's Model T and Benjamin Franklin's Franklin stove, as one of the top 100 best-designed mass-produced products, the result of a survey ...
A single temperature tap is commonly found in a commercial or public restroom where the temperature of the water will be controlled by a separate temperature regulating valve that mixes hot and cold water. The regulating valve may be under the handwashing sink or in a separate mechanical room or service closet.
Pulling up the stem of the cartridge opens the water supply; rotating toward the left opens the hot water passages while rotating to the right opens the cold water passages (using the standard North American convention of the hot water control on the left). Most Moen one-handle faucets produced since 2010 use the 1255 Duralast cartridge, which ...
A control valve is a valve used to control fluid flow by varying the size of the flow passage as directed by a signal from a controller. [1] This enables the direct control of flow rate and the consequential control of process quantities such as pressure, temperature, and liquid level.
Handwheel operated plug valve. The simplest and most common general type of plug valve is a 2-port valve [1] [2] with two positions: open to allow flow, and shut (closed) to stop flow. Ports are openings in the valve body through which fluid can enter or leave. The plug in this kind of valve has one passageway going through it.
The pressure-balanced shower valve compensates for changes in water pressure. It has a diaphragm or piston inside that reacts to relative changes in either hot or cold water pressure to maintain balanced pressure. As water pressure drops on one supply line, the valve reduces the pressure in the other supply line to match.
After flushing, the flapper valve in the water tank closes or the flush valve shuts; water lines and valves connected to the water supply refill the toilet tank and bowl. Then the toilet is again ready for use. If the forward ("flush") jet connection to the upper inlet in the toilet clogs, poor or no flushing action may result. [citation needed]