Search results
Results from the WOW.Com Content Network
Long division is the standard algorithm used for pen-and-paper division of multi-digit numbers expressed in decimal notation. It shifts gradually from the left to the right end of the dividend, subtracting the largest possible multiple of the divisor (at the digit level) at each stage; the multiples then become the digits of the quotient, and the final difference is then the remainder.
Apart from division by zero being undefined, the quotient is not an integer unless the dividend is an integer multiple of the divisor. For example, 26 cannot be divided by 11 to give an integer. Such a case uses one of five approaches: Say that 26 cannot be divided by 11; division becomes a partial function.
An orange that has been sliced into two halves. In mathematics, division by two or halving has also been called mediation or dimidiation. [1] The treatment of this as a different operation from multiplication and division by other numbers goes back to the ancient Egyptians, whose multiplication algorithm used division by two as one of its fundamental steps. [2]
Take each digit of the number (371) in reverse order (173), multiplying them successively by the digits 1, 3, 2, 6, 4, 5, repeating with this sequence of multipliers as long as necessary (1, 3, 2, 6, 4, 5, 1, 3, 2, 6, 4, 5, ...), and adding the products (1×1 + 7×3 + 3×2 = 1 + 21 + 6 = 28). The original number is divisible by 7 if and only if ...
A radix point is most often used in decimal (base 10) notation, when it is more commonly called the decimal point (the prefix deci-implying base 10). In English-speaking countries , the decimal point is usually a small dot (.) placed either on the baseline, or halfway between the baseline and the top of the digits ( · ) [ 25 ] [ a ] In many ...
Decimal numbers are not divided directly, the dividend and divisor are multiplied by a power of ten so that the division involves two whole numbers. Therefore, if one were dividing 12,7 by 0,4 (commas being used instead of decimal points), the dividend and divisor would first be changed to 127 and 4, and then the division would proceed as above.
Large-sized figures are often used to improve readability; while using decimal separator (usually a point rather than a comma) instead of or in addition to vulgar fractions. Various symbols for function commands may also be shown on the display. Fractions such as 1 ⁄ 3 are displayed as decimal approximations, for example rounded to 0.33333333.
Modern scientific calculators generally have many more capabilities than the original four- or five-function calculator, and the capabilities differ between manufacturers and models. The capabilities of a modern scientific calculator include: Scientific notation; Floating-point decimal arithmetic; Logarithmic functions, using both base 10 and ...