enow.com Web Search

  1. Ads

    related to: how to calculate pedal ratio of tires on truck trailer near me

Search results

  1. Results from the WOW.Com Content Network
  2. Slip (vehicle dynamics) - Wikipedia

    en.wikipedia.org/wiki/Slip_(vehicle_dynamics)

    In (automotive) vehicle dynamics, slip is the relative motion between a tire and the road surface it is moving on. This slip can be generated either by the tire's rotational speed being greater or less than the free-rolling speed (usually described as percent slip), or by the tire's plane of rotation being at an angle to its direction of motion (referred to as slip angle).

  3. Slip ratio - Wikipedia

    en.wikipedia.org/wiki/Slip_ratio

    Slip ratio is a means of calculating and expressing the slipping behavior of the wheel of an automobile.It is of fundamental importance in the field of vehicle dynamics, as it allows to understand the relationship between the deformation of the tire and the longitudinal forces (i.e. the forces responsible for forward acceleration and braking) acting upon it.

  4. Slip angle - Wikipedia

    en.wikipedia.org/wiki/Slip_angle

    The ratios between the slip angles of the front and rear axles (a function of the slip angles of the front and rear tires respectively) will determine the vehicle's behavior in a given turn. If the ratio of front to rear slip angles is greater than 1:1, the vehicle will tend to understeer, while a ratio of less than 1:1 will produce oversteer. [2]

  5. Motion ratio - Wikipedia

    en.wikipedia.org/wiki/Motion_ratio

    Motion ratio is the more common term in the industry, but sometimes is used to mean the inverse of the above definition. Motion ratio in suspension of a vehicle describes the amount of shock travel for a given amount of wheel travel. Mathematically, it is the ratio of shock travel and wheel travel.

  6. Wheelbase - Wikipedia

    en.wikipedia.org/wiki/Wheelbase

    where is the force on the front tires, is the force on the rear tires, is the distance from the CM to the rear wheels, is the distance from the CM to the front wheels, is the wheelbase, is the mass of the vehicle, is the acceleration of gravity (approx. 9.8 m/s 2), is the height of the CM above the ground, is the acceleration (or deceleration ...

  7. Tire uniformity - Wikipedia

    en.wikipedia.org/wiki/Tire_uniformity

    Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...

  8. Braking distance - Wikipedia

    en.wikipedia.org/wiki/Braking_distance

    Braking distance refers to the distance a vehicle will travel from the point when its brakes are fully applied to when it comes to a complete stop. It is primarily affected by the original speed of the vehicle and the coefficient of friction between the tires and the road surface, [Note 1] and negligibly by the tires' rolling resistance and vehicle's air drag.

  9. Tire code - Wikipedia

    en.wikipedia.org/wiki/Tire_code

    Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [24] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.

  1. Ads

    related to: how to calculate pedal ratio of tires on truck trailer near me