Search results
Results from the WOW.Com Content Network
Adhesive removers are intended to break down glue so that it can be removed from surfaces easily. [1] [2] [3] Formulations may be designed to remove a broad range of adhesives or to address a specific bond. [1] Many general purpose removers are intended to remove residue from adhesive tape. [1] [2] [3]
Masonry walls are built with a damp-proof course to prevent rising damp, and the concrete in foundations needs to be damp-proofed or waterproofed with a liquid coating, basement waterproofing membrane (even under the concrete slab floor where polyethylene sheeting is commonly used), or an additive to the concrete.
Decorative concrete is the use of concrete as not simply a utilitarian medium for construction but as an aesthetic enhancement to a structure, while still serving its function as an integral part of the building itself such as floors, walls, driveways, and patios. The transformation of concrete into decorative concrete is achieved through the ...
The adhesive properties of thinset are enhanced by adding polymers to the mixture, which also increases its flexibility and strength. [10] This advancement made it possible to install tile over a variety of surfaces, including concrete, plywood, and backer board, as well as in areas with more environmental exposure, like bathrooms and kitchens.
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
Construction adhesive being used to attach an access panel to drywall. The construction adhesive is in a caulking gun at the top of the image. Construction adhesive is a general-purpose adhesive used for attaching drywall , tile , molding , and fixtures to walls, ceilings, and floors. [ 1 ]
Slabs are one of the greatest consumers of concrete in many buildings, [14] so reducing the slab mass can make a relatively large difference to the environmental impact of a building's construction. Biaxial slabs may be marginally cheaper than solid slabs, partly due to the lower mass.
Some flooring components used solely on concrete slabs consist of a dimpled rubberized or plastic layer much like bubble wrap that provide little tiny pillars for the one-half-inch (12.7 mm) sheet material above. These are manufactured in 2 ft × 2 ft (61 cm × 61 cm) squares and the edges fit together like a mortise and tenon joint. Like a ...