enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Tipped tool - Wikipedia

   en.wikipedia.org/wiki/Tipped_tool

   Common materials for the cutters (brazed tips or clamped inserts) include cemented carbide, polycrystalline diamond, and cubic boron nitride. [1] Tools that are commonly tipped include milling cutters (such as end mills , face mills , and fly cutters ), tool bits , router bits , and saw blades (especially the metal-cutting ones).

3. Pocket-hole joinery - Wikipedia

   en.wikipedia.org/wiki/Pocket-hole_joinery

   Pocket screws have a wide washer head to spread the load for a firm bond, and prevent screwing too far into the joint and cracking the wood. The self tapping screws will grip any type of wood, but coarse threads are needed for softer wood and fine threads are needed for harder. [5]

4. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   Bits also differ by the diameter of their shank, with 1 ⁄ 2-inch, 12 mm, 10 mm, 3 ⁄ 8-inch, 8 mm and 1 ⁄ 4-inch and 6 mm shanks (ordered from thickest to thinnest) being the most common. Half-inch bits cost more but, being stiffer, are less prone to vibration (giving smoother cuts) and are less likely to break than the smaller sizes.

5. Confirmat screw - Wikipedia

   en.wikipedia.org/wiki/Confirmat_screw

   Confirmat screws on a sheet of the particleboard material in which they were designed to hold. Diagram of a hex-headed confirmat screw, made to be turned with an allen key A confirmat screw holding a butt joint in melamine-coated particleboard. A specialized stepped drill bit and a screw to match it. The screw is covered with a cosmetic plastic ...

6. Tool bit - Wikipedia

   en.wikipedia.org/wiki/Tool_bit

   Also, form tools wider than 2.5 times the smaller diameter of the part being turned have a greater risk of the part breaking off. [1] When turning longer lengths, a support from the turret can be used to increase turning length from 2.5 times to 5 times the smallest diameter of the part being turned, and this also can help reduce chatter.

7. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...