Search results
Results from the WOW.Com Content Network
Hydropneumatic suspension is a type of motor vehicle suspension system, invented by Paul Magès, produced by Citroën, and fitted to Citroën cars.The suspension was referred to as Suspension oléopneumatique [] in early literature, pointing to oil and air as its main components.
A continuously variable transmission (CVT) [12] allowing the tank to reach 70 km/h (43 mph) in both forward and reverse A faster autoloader allowing the main gun to fire every 3.5 seconds [ 13 ] A hydropneumatic suspension system [ 12 ] that provides improved recoil performance and chassis height adjustment
The gas precharge in an accumulator is set so that the separating bladder, diaphragm or piston does not reach or strike either end of the operating cylinder. The design precharge normally ensures that the moving parts do not foul the ends or block fluid passages. Poor maintenance of precharge can destroy an operating accumulator.
See also expansion tank. When shock waves of an incompressible fluid within a piping system exist, especially at a high velocity, there is a high chance for water hammer. To help prevent a swing check from slamming and causing water hammer, a spring-assisted non-slam check valve is installed.
When the 3.5-litre V8 engine was introduced in 1969, the sole transmission choice was a four-speed automatic with fluid coupling. The customers could request the four-speed manual transmission with price reduction if they inclined so. As for 4.5-litre V8 engine for the United States, the transmission was three-speed automatic with torque converter.
Oleo strut - design used in most large aircraft, with compressed gas and hydraulic fluid - conceptually similar to automobile Hydropneumatic suspension; Scrub radius; Short long arms suspension — also known as "unequal length A arm", one of the design parameters of double wishbone suspension; Strut bar — a part to make a suspension setup ...
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Pages for logged out editors learn more
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation: