Search results
Results from the WOW.Com Content Network
Ballast-swap replacement for 8 ft T12 75 W single-pin T12: 1.5, 38: 4 "25" F40UTSL Retrofit replacement for 4 ft T12 40 W on underpowered residential-grade rapid start magnetic ballasts. These are F40CW lamps made with lighter cathodes that can only handle a lower amount of power.
The latter use a standard light switch, and the on-board electronics chooses the light output level based on the number of times the switch is turned on and off quickly. Dimmable CFLs are not a 100% replacement for incandescent fixtures that are dimmed for "mood scenes" such as wall sconces in a dining area.
Because of the presence of a neutral fuse, and in the event that it blew, the neutral conductor could not be relied on to remain near ground potential; and, in fact, could be at full line potential (via transmission of voltage through a switched-on light bulb, for example). [5] Modern electrical codes generally do not require a neutral fuse.
The most common residential and small commercial service in Canada and the U.S., single split-phase, 240 V, features a neutral and two hot legs, 240 V to each other, and 120 V each to the neutral. The most common three-phase system will have three hot legs, 208 V to each other and 120 V each to the neutral.
In building wiring, multiway switching is the interconnection of two or more electrical switches to control an electrical load from more than one location.A common application is in lighting, where it allows the control of lamps from multiple locations, for example in a hallway, stairwell, or large room.
A light fixture (US English), light fitting (UK English), or luminaire is an electrical lighting device containing one or more light sources, such as lamps, and all the accessory components required for its operation to provide illumination to the environment. [1] All light fixtures have a fixture body and one or more lamps.
The most commonly used A-series light bulb type is an A60 bulb [7] (or its inch-based equivalent, the A19 bulb [2] [4]), which is 60 mm (19 ⁄ 8 in or 2 + 3 ⁄ 8 in) wide at its widest point [3] and approximately 110 mm (4 + 3 ⁄ 8 in) in length. [8] Other sizes with a data sheet in IEC 60064 are A50, A55, A67, A68, A71, A75, and A80.
Although it is easy to design, it has dramatic problems with glare and excess energy consumption due to large number of fittings. [11] The introduction of LED lighting has greatly improved this by approx. 90% when compared to a halogen downlight or spotlight. LED lamps or bulbs are now available to retro fit in place of high energy consumption ...