Search results
Results from the WOW.Com Content Network
Inspection may be manual, conducted by an inspector using imaging equipment, or automated using machine vision. [citation needed] Since the similarity of materials between weld and workpiece, and between good and defective areas, provides little inherent contrast, the latter usually requires methods other than simple imaging.
A PMCS check is required before, during, and after a piece of equipment or vehicle is used. Checks are also done at weekly, monthly, semi-annual, annual, or bi-annual intervals, depending on the specific part. [1] Doing a PMCS check every time equipment is used may reduce the number of failures.
In addition to welders and welding machine operators, there are also schemes to independently certify welding inspectors and related specialities. The duties of the welding inspector are described in ISO 14731; [12] however the requirement for inspector certification are not standardized, so there are differences in requirement between the various schemes.
First article inspection is typically a purchase order requirement of the purchaser for the supplier to complete. If the manufacturer doesn't have the in-house capability or if the purchaser requests, the first article inspection may be conducted by an approved subcontract supplier such as a dimensional inspection/metrology laboratory.
The Canadian Welding Bureau, through CSA Standards W47.1, [3] W47.2 [4] and W186, [5] specifies both a WPS and a Welding Procedure Data Sheet (WPDS) to provide direction to the welding supervisor, welders and welding operators. The WPS provides general information on the welding process and material grouping being welded, while the WPDS ...
During laser welding, air bubbles can form and cause a degradation in the mechanical properties of the joint. Current inspection techniques are limited to finding air bubbles on the surface of the weld (optical and scanning electron microscopy). Destructive testing is usually required to find volumetric flaws.
Welding - General tolerances for welded constructions - Dimensions for lengths and angles - Shape and position ISO 14112: Gas welding equipment - Small kits for gas brazing and welding ISO 14175: Welding consumables — Gases and gas mixtures for fusion welding and allied processes. Replaced EN 439:1994 in Europe. ISO 14341: Welding consumables.
Risk-based inspection (RBI) is an optimal maintenance business process used to examine equipment such as pressure vessels, quick-opening closure - doors, heat exchangers, and piping in industrial plants. RBI is a decision-making methodology for optimizing inspection plans.