Search results
Results from the WOW.Com Content Network
Closed-cycle gas turbine schematic C compressor and T turbine assembly w high-temperature heat exchanger ʍ low-temperature heat exchanger ~ mechanical load, e.g. electric generator. A closed-cycle gas turbine is a turbine that uses a gas (e.g. air, nitrogen, helium, argon, [1] [2] etc.) for the working fluid as part of a closed thermodynamic ...
Diagram of a steam turbine generator system. The control of a turbine with a governor is essential, as turbines need to be run up slowly to prevent damage and some applications (such as the generation of alternating current electricity) require precise speed control. [26]
A turbo generator is an electric generator connected to the shaft of a turbine (water, steam, or gas) for the generation of electric power. [ note 1 ] Large steam-powered turbo generators provide the majority of the world's electricity and are also used by steam-powered turbo-electric ships.
The bearings have to be leak-tight. A hermetic seal, usually a liquid seal, is employed; a turbine oil at pressure higher than the hydrogen inside is typically used. A metal, e.g. brass, ring is pressed by springs onto the generator shaft, the oil is forced under pressure between the ring and the shaft; part of the oil flows into the hydrogen side of the generator, another part to the air side.
A typical one-line diagram with annotated power flows. Red boxes represent circuit breakers, grey lines represent three-phase bus and interconnecting conductors, the orange circle represents an electric generator, the green spiral is an inductor, and the three overlapping blue circles represent a double-wound transformer with a tertiary winding.
A typical single-shaft system has one gas turbine, one steam turbine, one generator and one heat recovery steam generator (HRSG). The gas turbine and steam turbine are both coupled in tandem to a single electrical generator on a single shaft. This arrangement is simpler to operate, smaller, with a lower startup cost.
A simple-cycle combustion turbine (SCCT) is a type of gas turbine typically used in the power generation, aviation , and oil and gas industries (for electricity generation and mechanical drives). The simple-cycle combustion turbine follows the Brayton Cycle and differs from a combined cycle operation in that it has only one power cycle (i.e. no ...
U.S. NRC image of a modern steam turbine generator (STG). In electricity generation, a generator [1] is a device that converts motion-based power (potential and kinetic energy) or fuel-based power (chemical energy) into electric power for use in an external circuit.