enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Schrader valve - Wikipedia

   en.wikipedia.org/wiki/Schrader_valve

   The Schrader valve consists of a valve stem into which a valve core is threaded. The valve core is a poppet valve assisted by a spring. A small rubber seal located on the core keeps the fluid from escaping through the threads. Using the appropriate tools, a faulty valve core can be immediately extracted from the valve stem and replaced with a ...

3. Valve stem - Wikipedia

   en.wikipedia.org/wiki/Valve_stem

   An inflator stem is not used; instead, a removable cap on a valve stem embedded in the tire rim is fitted, with only the cap visible. When inflating the tire, the cap is first removed, typically with a coin, and then a "portable" dedicated inflator stem is screwed onto the valve stem. Through the inflator, the tire is inflated as usual.

4. Valve guide - Wikipedia

   en.wikipedia.org/wiki/Valve_guide

   The upper part of the valve stem, within the rocker box, is lubricated by oil. If this oil travels unchecked along the valve stem, engine HC emissions will become excessive. To control this, an elastomeric seal is fitted over the top of the valve guide. These may wear or stiffen with age, so are usually replaced whenever valves are removed for ...

5. Presta valve - Wikipedia

   en.wikipedia.org/wiki/Presta_valve

   The Presta valve (also French valve (FV) or Sclaverand valve) is a type of tire valve commonly found on high pressure bicycle inner tubes and is commonly used on tubeless setups. It consists of an outer valve stem and an inner valve body. A lock nut to secure the stem at the wheel rim and a valve cap may also be present.

6. Saginaw 9.5-inch axle - Wikipedia

   en.wikipedia.org/wiki/Saginaw_9.5-inch_axle

   The GM 9.25 IFS has been the main front differential in Four-wheel drive 3/4 Ton and 1 Ton GM trucks since 1988. The Dana 60 solid axle front end was used selectively in trucks with a higher GVWR from 1988 to 1991. The original Saginaw 9.5 differential, ring and pinion were modified to work with the independent front suspension.

7. Ram pickup - Wikipedia

   en.wikipedia.org/wiki/Ram_pickup

   The Ram 3500 has three axle ratios (3.42, 3.73, and 4.10) and 17" wheels. Ram 4500/5500 has three axle ratios (4.10, 4.44, and 4.88) and 19.5-inch wheels. The 4500/5500 Rams rear axle is a Dana S 110. The front axle on 4×4 models is manufactured by Magna, while 2-wheel-drive models just have a solid, non-drive axle.