Search results
Results from the WOW.Com Content Network
A gain greater than one (greater than zero dB), that is, amplification, is the defining property of an active device or circuit, while a passive circuit will have a gain of less than one. [4] The term gain alone is ambiguous, and can refer to the ratio of output to input voltage (voltage gain), current (current gain) or electric power (power ...
The return ratio of a dependent source in a linear electrical circuit is the negative of the ratio of the current (voltage) returned to the site of the dependent source to the current (voltage) of a replacement independent source.
The loop gain is calculated by imagining the feedback loop is broken at some point, and calculating the net gain if a signal is applied. In the diagram shown, the loop gain is the product of the gains of the amplifier and the feedback network, −Aβ. The minus sign is because the feedback signal is subtracted from the input.
It is the amount of gain, which can be increased or decreased without making the system unstable2. For a stable system, both the margins should be positive, or the phase margin should be greater than the gain margin1. For a marginally stable system, the margins should be zero or the phase margin should be equal to the gain margin.
For transistors, the current-gain–bandwidth product is known as the f T or transition frequency. [4] [5] It is calculated from the low-frequency (a few kilohertz) current gain under specified test conditions, and the cutoff frequency at which the current gain drops by 3 decibels (70% amplitude); the product of these two values can be thought of as the frequency at which the current gain ...
The gain of a good quality full-range audio amplifier will be essentially flat between 20 Hz to about 20 kHz (the range of normal human hearing). In ultra-high-fidelity amplifier design, the amplifier's frequency response should extend considerably beyond this (one or more octaves either side) and might have −3 dB points < 10 Hz and > 65 kHz .
In electronics the amplification factor, or gain, is the ratio of the output to the input of an amplifier, sometimes represented by the symbol A F. In numerical analysis the amplification factor is a number derived using Von Neumann stability analysis to determine stability of a numerical scheme for a partial differential equation .
where is the voltage gain of the inverting amplifier (positive) and is the feedback capacitance. Although the term Miller effect normally refers to capacitance, any impedance connected between the input and another node exhibiting gain can modify the amplifier input impedance via this effect.