Search results
Results from the WOW.Com Content Network
Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [24] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.
Motion ratio is the more common term in the industry, but sometimes is used to mean the inverse of the above definition. Motion ratio in suspension of a vehicle describes the amount of shock travel for a given amount of wheel travel. Mathematically, it is the ratio of shock travel and wheel travel.
Slip ratio is a means of calculating and expressing the slipping behavior of the wheel of an automobile.It is of fundamental importance in the field of vehicle dynamics, as it allows to understand the relationship between the deformation of the tire and the longitudinal forces (i.e. the forces responsible for forward acceleration and braking) acting upon it.
The ratios between the slip angles of the front and rear axles (a function of the slip angles of the front and rear tires respectively) will determine the vehicle's behavior in a given turn. If the ratio of front to rear slip angles is greater than 1:1, the vehicle will tend to understeer, while a ratio of less than 1:1 will produce oversteer. [2]
Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...
Directly below the air hose on the side of the tire changer is the inflation pedal that enables the inflation of the tire. [2] When the inflation pedal is raised, a burst of air is released from valves next to each rim clamp toward the bottom bead of the tire to help with inflation. The manual bleed valve is located next to the air hose and air ...
If the tire is not checked, it has the potential to cause vibration in the suspension of the vehicle on which it is mounted. In tire retail shops, tire/wheel assemblies are checked on a spin-balancer, which determines the amount and angle of unbalance. Balance weights are then fitted to the outer and inner flanges of the wheel. [2]
TTI HS-20 allowed shorter trucks to have higher weight limits than Formula B. For a 3-axle truck with an axle length of 14 feet (4.3 m), the weight limit increased from 46,500 pounds (21,100 kg) to 54,000 pounds (24,000 kg). [29] TTI HS-20 also failed to address the problem of multiple-span bridges. [28]