Search results
Results from the WOW.Com Content Network
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
Every pipes should me marked with pipe sizes. If the drawing is detailed, fixture units also should be marked along with the pipe. [1] [2] In the realm of shop drawings, additional clarity is achieved by incorporating sections that reveal the intersection points of various pipes. These sections serve as visual guides, ensuring that the ...
Gooseneck vent with check valve being repainted. A gooseneck (or goose neck) is a 180° pipe fitting at the top of a vertical pipe that prevents entry of water. Common implementations of goosenecks are ventilator piping or ducting for bathroom and kitchen exhaust fans, ship holds, landfill methane vent pipes, or any other piping implementation exposed to the weather where water ingress would ...
Vertical pipes, usually made of precast concrete, called manholes, connect the mains to the surface. Depending upon site application and use, these vertical pipes can be cylindrical, eccentric, or concentric. The manholes are used for access to the sewer pipes for inspection and maintenance, and as a means to vent sewer gases.
A Blair toilet with an exhaust pipe. The Blair Toilet (a.k.a. Blair Latrine) is a pit toilet designed in the 1970s. It was a result of large-scale projects to improve rural sanitation in Rhodesia under UDI at the Blair Research Institute, and then deployed further during the 1980s after Zimbabwean Independence. There was mass deployment of the ...
The vent pipe should have an internal diameter of at least 110 mm (4¼") and reach more than 300 mm (12") above the highest point of the toilet superstructure. Typically, the pit is at least 3 metres (10') deep and 1 to 1.5 metres (3' to 5') in diameter, depending on the number of users. Deep pits can last up to 20 or more years. [30]
A main component of the base section is a channel that provides a smooth conduit for wastewater to flow from inlet pipe to outlet pipe. The channel is in a U shape formed by a "half pipe" as if a pipe is cut in half and left with the bottom half. The width of the channel should match the inside diameter of the inlet and outlet pipes.
The pipes were hollowed-out logs which were tapered at the end with a small hole in which the water would pass through. [23] The multiple pipes were then sealed together with hot animal fat. Wooden pipes were used in Philadelphia, [24] Boston, and Montreal in the 1800s. Built-up wooden tubes were widely used in the US during the 20th century.