enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   self-drilling screw Tek screw: Similar to a sheet metal screw, but it has a drill-shaped point to cut through the substrate to eliminate the need for drilling a pilot hole. Designed for use in soft steel or other metals. The points are numbered from 1 through 5; the larger the number, the thicker metal it can go through without a pilot hole.

3. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, fine): For 7 ⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw). The drill sizes that are near this are ...

4. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   A self-tapping screw is a screw that can tap its own hole as it is driven into the material. More narrowly, self-tapping is used only to describe a specific type of thread-cutting screw intended to produce a thread in relatively soft material or sheet materials, excluding wood screws .

5. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 3 ⁄ 8 in for a 3 ⁄ 8-16 tap), and / is the thread pitch (1 ⁄ 16 inch in the case of a 3 ⁄ 8-16 tap). For a 3 ⁄ 8 -16 tap, the above formula would produce 5 ⁄ 16 , which is the correct tap drill diameter.

6. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...

7. Pilot hole - Wikipedia

   en.wikipedia.org/wiki/Pilot_hole

   By drilling a small pilot hole into the material, into which a screw is then driven, less wedging takes place, thereby reducing the likelihood of the material being split. [2] When a screw is driven without a pilot hole, or with too small a pilot hole, the core of the screw may bind and lead to the screw being broken.