enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Current sensing - Wikipedia

   en.wikipedia.org/wiki/Current_sensing

   The design of the saturable inductor current sensor is similar to that of a closed-loop Hall-effect current sensor; the only difference is that this method uses the saturable inductor instead of the Hall-effect sensor in the air gap. Saturable inductor current sensor is based on the detection of an inductance change. The saturable inductor is ...

3. List of electrical and electronic measuring equipment

   en.wikipedia.org/wiki/List_of_electrical_and...

   Megger tester: Measures Resistance of an Winding of Motor or Generator And Measures Earthing's Resistance Microwave power meter: Measures power at microwave frequencies Multimeter: General purpose instrument measures voltage, current and resistance (and sometimes other quantities as well) Network analyzer: Measures network parameters Ohmmeter

4. Current clamp - Wikipedia

   en.wikipedia.org/wiki/Current_clamp

   Meters which respond to true RMS rather than mean current are described as "true RMS". Typical hand-held Hall effect units can read currents as low as 200 mA, and units that can read down to 1 mA are available. The Columbia tong test ammeter (illustrated) is an example of the iron vane type, used for measuring large AC currents up to 1000 amperes.

5. List of measuring instruments - Wikipedia

   en.wikipedia.org/wiki/List_of_measuring_instruments

   Light meter, an instrument used to set photographic exposures. It can be either a lux meter (incident-light meter) or a luminance meter (reflected-light meter), and is calibrated in photographic units. Integrating sphere for collecting the total luminous flux of a light source, which can then be measured by a photometer

6. Class of accuracy in electrical measurements - Wikipedia

   en.wikipedia.org/wiki/Class_of_accuracy_in...

   Ideally the measuring device should not affect the circuit parameters i.e., the internal impedance of the ammeter should be zero (no voltage drop over the ammeter) and the internal impedance of the voltmeter should be infinite (no current through the voltmeter). However, in actual case, ammeters have a low but non zero impedance and voltmeters ...

7. Ammeter - Wikipedia

   en.wikipedia.org/wiki/Ammeter

   Demonstration model of a moving iron ammeter. As the current through the coil increases, the plunger is drawn further into the coil and the pointer deflects to the right. An ammeter (abbreviation of ampere meter) is an instrument used to measure the current in a circuit. Electric currents are measured in amperes (A), hence the name. For direct ...

8. Multimeter - Wikipedia

   en.wikipedia.org/wiki/Multimeter

   This is a current-loaded measurement, which simulates in-use battery loads; normal voltage ranges draw very little current from the battery. Various sensors can be attached to (or included in) multimeters to take measurements such as: Luminance; Sound pressure level; pH; Relative humidity; Very small current flow (down to nanoamps with some ...

9. Rogowski coil - Wikipedia

   en.wikipedia.org/wiki/Rogowski_coil

   These sensors share the principles of a Rogowski coil, measuring the rate of change of current using a transformer with no magnetic core. The difference from the traditional Rogowski coil is that the sensor can be manufactured using a planar coil rather than a toroidal coil.