Search results
Results from the WOW.Com Content Network
RS-485, also known as TIA-485(-A) or EIA-485, is a standard, originally introduced in 1983, defining the electrical characteristics of drivers and receivers for use in serial communications systems. Electrical signaling is balanced , and multipoint systems are supported.
Packet loss is either caused by errors in data transmission, typically across wireless networks, [1] [2] or network congestion. [3]: 36 Packet loss is measured as a percentage of packets lost with respect to packets sent. The Transmission Control Protocol (TCP) detects packet loss and performs retransmissions to ensure reliable messaging.
When a packet is lost, rather than losing an entire set of data, small portions of several sets will be gone. At the receiving end, the message is then deinterleaved to reveal the original message with minimal loss. Transmission without interleaving:
The start of a packet is signified by a break followed by a "mark" (a logical one), known as the "Mark After Break" (MAB). The break, which signals the end of one packet and the start of another, causes receivers to start reception and also serves as a frame (position reference) for data bytes within the packet. Framed data bytes are known as ...
High-Level Data Link Control (HDLC) is a communication protocol used for transmitting data between devices in telecommunication and networking.Developed by the International Organization for Standardization (ISO), it is defined in the standard ISO/IEC 13239:2002.
Modbus or MODBUS is a client/server data communications protocol in the application layer. [1] It was originally designed for use with programmable logic controllers (PLCs), [2] but has become a de facto standard communication protocol for communication between industrial electronic devices in a wide range of buses and networks.
As with TCP, the NORM congestion control scheme assumes packet loss is due to buffer overflows, and the sender consequently backs off it transmission rate when packet loss reaches a specified level. This can lead to limitations in wireless networks, where packet loss is often due to bit errors or contention.
Depending on the physical layer protocol or encoding used, the pause may be necessary to allow for receiver clock recovery, permitting the receiver to prepare for another packet (e.g. powering up from a low-power state) or another purpose.