enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Cooling load temperature difference calculation method

   en.wikipedia.org/wiki/Cooling_load_temperature...

   These variables include, building material of the envelope, thicknesses of the building materials, day of the year, time of day, orientation of the surface (e.g. wall or roof, 90 degrees or 180), and wall face orientation (cardinal directions, i.e. N, NW, S, SE, etc.), to name a few.

3. Thermal transmittance - Wikipedia

   en.wikipedia.org/wiki/Thermal_transmittance

   These heat flux meters usually consist of thermopiles which provide an electrical signal which is in direct proportion to the heat flux. Typically they might be about 100 mm (3.9 in) in diameter and perhaps about 5 mm (0.20 in) thick and they need to be fixed firmly to the roof or wall which is under test in order to ensure good thermal contact.

4. Air changes per hour - Wikipedia

   en.wikipedia.org/wiki/Air_changes_per_hour

   A new parameter, effective Air Changes per Hour (called ACHH by Mojtaba Zabihi et. al. [8]), which incorporates both the flow rate and large-scale airflow patterns, could provide a more accurate measure of how efficiently air is supplied and circulated within a room. This is particularly important for effectively managing airborne disease spread.

5. Square (unit) - Wikipedia

   en.wikipedia.org/wiki/Square_(unit)

   The square is an Imperial unit of area that is used in the construction industry in the United States and Canada, [1] and was historically used in Australia. One square is equal to 100 square feet. Examples where the unit is used are roofing shingles, metal roofing, vinyl siding, and fibercement siding products.

6. Floor area ratio - Wikipedia

   en.wikipedia.org/wiki/Floor_area_ratio

   For example, if a lot must adhere to a 0.1 FAR, then the total area of all floors in all buildings on the lot must be no more than one-tenth the area of the parcel itself. In other words, if the lot was 10,000 sq. ft, then the total floor area of all floors in all buildings must not exceed 1,000 sq. ft.

7. Sol-air temperature - Wikipedia

   en.wikipedia.org/wiki/Sol-air_temperature

   Sol-air temperature (T sol-air) is a variable used to calculate cooling load of a building and determine the total heat gain through exterior surfaces. It is an improvement over: It is an improvement over: