enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Cooling load temperature difference calculation method

   en.wikipedia.org/wiki/Cooling_load_temperature...

   These variables include, building material of the envelope, thicknesses of the building materials, day of the year, time of day, orientation of the surface (e.g. wall or roof, 90 degrees or 180), and wall face orientation (cardinal directions, i.e. N, NW, S, SE, etc.), to name a few.

3. Sol-air temperature - Wikipedia

   en.wikipedia.org/wiki/Sol-air_temperature

   Sol-air temperature (T sol-air) is a variable used to calculate cooling load of a building and determine the total heat gain through exterior surfaces. It is an improvement over: It is an improvement over:

4. Air changes per hour - Wikipedia

   en.wikipedia.org/wiki/Air_changes_per_hour

   R p = ventilation rate per person (cubic feet per minute (CFM) per person or cubic meters per minute per person) ACPH = Air changes per hour; D = Occupant density (square feet per occupant or square meters per occupant) h = Ceiling height (feet or meters) One cubic meter per minute = 16.67 liter/second

5. Square (unit) - Wikipedia

   en.wikipedia.org/wiki/Square_(unit)

   The square is an Imperial unit of area that is used in the construction industry in the United States and Canada, [1] and was historically used in Australia. One square is equal to 100 square feet. Examples where the unit is used are roofing shingles, metal roofing, vinyl siding, and fibercement siding products.

6. Flat roof - Wikipedia

   en.wikipedia.org/wiki/Flat_roof

   A study by Ducker International in 2005 identified the average cost per year of a metal roof to be US$3.2 per square metre ($0.30/sq ft) while single-ply roofs stood at $6.1/m 2 ($0.57/sq ft) and built-up roofing at $4.0/m 2 ($0.37/sq ft).

7. Floor area ratio - Wikipedia

   en.wikipedia.org/wiki/Floor_area_ratio

   For example, if a lot must adhere to a 0.1 FAR, then the total area of all floors in all buildings on the lot must be no more than one-tenth the area of the parcel itself. In other words, if the lot was 10,000 sq. ft, then the total floor area of all floors in all buildings must not exceed 1,000 sq. ft.