enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drive shaft - Wikipedia

   en.wikipedia.org/wiki/Drive_shaft

   A drive shaft, driveshaft, driving shaft, tailshaft (Australian English), propeller shaft (prop shaft), or Cardan shaft (after Girolamo Cardano) is a component for transmitting mechanical power, torque, and rotation, usually used to connect other components of a drivetrain that cannot be connected directly because of distance or the need to ...

3. Run-out - Wikipedia

   en.wikipedia.org/wiki/Run-out

   Radial run-out is caused by the tool being translated off the machine axis, still parallel. Radial run-out will measure the same all along the machine axis. Axial run-out is caused by the tool or component being at an angle to the axis. Axial run-out causes the tip of the tool or shaft to rotate off-centre relative to the base.

4. Hotchkiss drive - Wikipedia

   en.wikipedia.org/wiki/Hotchkiss_drive

   Most shaft-drive systems consist of a drive shaft (also called a "propeller shaft" or Cardan shaft) extending from the transmission in front to the differential in the rear. The differentiating characteristic of the Hotchkiss drive is the fact that the axle housing is firmly attached to the leaf springs to transfer the axle torque through them ...

5. Driveshaft - Wikipedia

   en.wikipedia.org/?title=Driveshaft&redirect=no

   Printable version; In other projects Appearance. move to sidebar hide. From Wikipedia, the free encyclopedia. Redirect page. Redirect to: Drive shaft; Retrieved from ...

6. Torque - Wikipedia

   en.wikipedia.org/wiki/Torque

   Torque forms part of the basic specification of an engine: the power output of an engine is expressed as its torque multiplied by the angular speed of the drive shaft. Internal-combustion engines produce useful torque only over a limited range of rotational speeds (typically from around 1,000–6,000 rpm for a small car).

7. Muncie SM465 transmission - Wikipedia

   en.wikipedia.org/wiki/Muncie_SM465_transmission

   There have been three different output shafts for pickup trucks. Early four-wheel drive was a short 10 spline. Later, a 35-spline version was for 2 wheel drive, whereas 4WD units had a 32-spline output shaft. [1] The SM465 was the only manual transmission available for 1988-1991 R/V-series trucks and SUVs. [citation needed]

8. Spiral bevel gear - Wikipedia

   en.wikipedia.org/wiki/Spiral_bevel_gear

   Spiral bevel gear. A spiral bevel gear is a bevel gear with helical teeth. The main application of this is in a vehicle differential, where the direction of drive from the drive shaft must be turned 90 degrees to drive the wheels.

9. Quill drive - Wikipedia

   en.wikipedia.org/wiki/Quill_drive

   A quill drive is a mechanism that allows a drive shaft to shift its position (either axially, radially, or both) relative to its driving shaft. It consists of a hollow driving shaft (the quill) with a driven shaft inside it. The two are connected in some fashion which permits the required motion.