Search results
Results from the WOW.Com Content Network
Diagram of spray-up process. Spray-Up also known as chop method of creating fiberglass objects by spraying short strands of glass out of a pneumatic gun. This method is used often when one side of the finished product is not seen, or when large quantities of a product must be made cheaply and quickly with moderate strength requirements. [1]
Bondo is a polyester putty product originally marketed as an automotive body filler. Nowadays the brand name is used by 3M for a line of American-made products for automotive, marine and household repairs. [1] [2] The term Bondo is trademarked by 3M, but is commonly used to refer to any brand of automotive repair putty due to its popularity.
The resin and hardener part together is known as the "Binder". As the name indicates, in Fusion bonded epoxy coatings the resin part is an "epoxy" type resin. “Epoxy” or “Oxirane” structure contains a three membered cyclic ring — one oxygen atom connected to two carbon atoms – in the resin molecule. This part is the most reactive ...
The fiberglass used will typically be identical to that which will be used in the final product. In the laying-up process, a layer of fiberglass mat is applied, and resin is applied over it. A special roller is then used to remove air bubbles. Air bubbles, if left in the curing resin, would significantly reduce the strength of the finished mold.
When using latent hardeners, the epoxy resin and hardener may be mixed and stored for some time prior to use, which is advantageous for many industrial processes. Very latent hardeners enable one-component (1K) products to be produced, whereby the resin and hardener are supplied pre-mixed to the end user and only require heat to initiate curing.
J-B Weld is a two-part epoxy adhesive (or filler) that can withstand high-temperature environments. J-B Weld can be used to bond surfaces made from metal, porcelain, ceramic, glass, marble, PVC, ABS, concrete, fiberglass, wood, fabric, or paper. [7] [8] Alcohol should be avoided when cleaning surfaces, as it can degrade the bond. [9]
Alternately, resin casting may be accomplished with a resin plus a nearly equal amount of a "hardener" liquid (as in many epoxy resin or polyester resin systems), which functionally contains a second polymer, for use in forming a final product plastic which is a copolymer. Copolymers contain two different alternating chemical entities in the ...
This type of resin is known as a Nadic resin and is referred to as a poor man's Ortho, due to sharing many similar properties of an Ortho resin along with the extremely low cost of DCPD raw material. In another process, maleic anhydride is first opened with water or another alcohol to form maleic acid and is then reacted with DCPD where an ...