enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bondo (putty) - Wikipedia

   en.wikipedia.org/wiki/Bondo_(putty)

   Bondo is a polyester putty product originally marketed as an automotive body filler. Nowadays the brand name is used by 3M for a line of American-made products for automotive, marine and household repairs. [1] [2] The term Bondo is trademarked by 3M, but is commonly used to refer to any brand of automotive repair putty due to its popularity.

3. Fiberglass spray lay-up process - Wikipedia

   en.wikipedia.org/wiki/Fiberglass_spray_lay-up...

   Diagram of spray-up process. Spray-Up also known as chop method of creating fiberglass objects by spraying short strands of glass out of a pneumatic gun. This method is used often when one side of the finished product is not seen, or when large quantities of a product must be made cheaply and quickly with moderate strength requirements. [1]

4. Case modding - Wikipedia

   en.wikipedia.org/wiki/Case_modding

   Spray paint is the most common method preferred among amateur modders. [12] There are many spray painting guides for amateur modders. This finish cannot be compared to automotive paint or powder coating (see Less common modifications), but it is a simple way to change the look of a case. Re-coloring the plastics of a case, keyboard, mouse and ...

5. Fusion bonded epoxy coating - Wikipedia

   en.wikipedia.org/wiki/Fusion_bonded_epoxy_coating

   The resin and hardener part together is known as the "Binder". As the name indicates, in Fusion bonded epoxy coatings the resin part is an "epoxy" type resin. “Epoxy” or “Oxirane” structure contains a three membered cyclic ring — one oxygen atom connected to two carbon atoms – in the resin molecule. This part is the most reactive ...

6. Polyester resin - Wikipedia

   en.wikipedia.org/wiki/Polyester_resin

   This type of resin is known as a Nadic resin and is referred to as a poor man's Ortho, due to sharing many similar properties of an Ortho resin along with the extremely low cost of DCPD raw material. In another process, maleic anhydride is first opened with water or another alcohol to form maleic acid and is then reacted with DCPD where an ...

7. Fiberglass molding - Wikipedia

   en.wikipedia.org/wiki/Fiberglass_molding

   The fiberglass used will typically be identical to that which will be used in the final product. In the laying-up process, a layer of fiberglass mat is applied, and resin is applied over it. A special roller is then used to remove air bubbles. Air bubbles, if left in the curing resin, would significantly reduce the strength of the finished mold.