Search results
Results from the WOW.Com Content Network
A log splitter is a piece of machinery or equipment used for splitting firewood from softwood or hardwood logs that have been pre-cut into sections (rounds), usually by chainsaw or on a saw bench. Many log splitters consist of a hydraulic pump or electric motor which then powers a hydraulic or electrical rod and piston assembly.
With manual type splitter, the wedge type splitter requires 20~25 cm space, while piston type splitter requires 40~50 cm. Larger size wedge splitter requires large spacing as much as 50~70 cm. Large size piston splitter requires 60~100 cm spacing . Large size wedge splitter or piston splitter is mounted on a vehicle like excavator.
Log splitting is the act of splitting firewood from logs that have been pre-cut into sections (rounds, bolts, billets [3]). This can be done by hand, using an axe or maul, or by using a mechanical log splitter. [4] When splitting a log by hand, it is best to aim for the cracks (called checks), if there are any visible. [5]
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
Diagram showing the construction of a typical leaded hub joint. Cast iron piping was traditionally made with one "spigot" end (plain, which was cut to length as needed) and one "socket" or "hub" end (cup-shaped). The larger-diameter hub was also called a "bell" because of its shape.
A Eucalyptus being felled using springboards, c. 1884–1917, Australia McGiffert Log Loader in East Texas, US, c. 1907 Lumber under snow in Montgomery, Colorado, 1880s. Logging is the process of cutting, processing, and moving trees to a location for transport.
The most common vehicle uses of master cylinders are in brake and clutch systems.. In brake systems, the operated devices are cylinders inside brake calipers and/or drum brakes; these cylinders may be called wheel cylinders or slave cylinders, and they push the brake pads towards a surface that rotates with the wheel (this surface is typically either a drum or a disc, a.k.a. a rotor) until the ...
The cylinders and tubes are filled with an incompressible liquid. The two cylinders have the same volume, but different diameters, and thus different cross-section areas. The cylinder that the operator uses is called the master cylinder. The spinning disc brake will be adjacent to the piston with the larger cross-section.