enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. ipconfig - Wikipedia

    en.wikipedia.org/wiki/Ipconfig

    Then, the command ipconfig /renew is executed to request a new IP address. [ 3 ] [ 4 ] Where a computer is connected to a cable or DSL modem, it may have to be plugged directly into the modem network port to bypass the router, before using ipconfig /release and turning off the power for a period of time, to ensure that the old IP address is ...

  3. ifconfig - Wikipedia

    en.wikipedia.org/wiki/Ifconfig

    Linux also features iwspy, to read the signal, noise and quality of a wireless connection. Other related tools for configuring Ethernet adapters are: ethtool, mii-tool, and mii-diag in Linux and the command dladm show-link in Solaris. The ip suite has a similar purpose and is meant to replace the deprecated ifconfig. [6]

  4. UDP Helper Address - Wikipedia

    en.wikipedia.org/wiki/UDP_Helper_Address

    To enable the forwarding of User Datagram Protocol (UDP) broadcasts, including BOOTP, received on an interface, use the ip helper-address command in interface configuration mode. To disable the forwarding of broadcast packets to specific addresses, use the no form of this command. Syntax Description: ip helper-address [vrf name | global ...

  5. Subnet - Wikipedia

    en.wikipedia.org/wiki/Subnet

    Since the introduction of CIDR, however, the assignment of an IP address to a network interface requires two parameters, the address and a subnet mask. Given an IPv4 source address, its associated subnet mask, and the destination address, a router can determine whether the destination is on a locally connected network or a remote network.

  6. Zero-configuration networking - Wikipedia

    en.wikipedia.org/wiki/Zero-configuration_networking

    Where no DHCP server is available to assign a host an IP address, the host can select its own link-local address. Using a link-local address, hosts can communicate over this link but only locally; Access to other networks and the Internet is not possible. There are some link-local IPv4 address implementations available:

  7. Link-local address - Wikipedia

    en.wikipedia.org/wiki/Link-local_address

    Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.

  8. iproute2 - Wikipedia

    en.wikipedia.org/wiki/Iproute2

    Replacement command Note ifconfig: ip addr, ip link: Address and link configuration route: ip route: Routing tables arp: ip neigh: Neighbors iptunnel: ip tunnel: Tunnels nameif, ifrename: ip link set name: Rename network interfaces ipmaddr: ip maddr: Multicast netstat: ss, ip route: Show various networking statistics brctl: bridge: Handle ...

  9. route (command) - Wikipedia

    en.wikipedia.org/wiki/Route_(command)

    COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router