enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Bipolar transistor biasing - Wikipedia

    en.wikipedia.org/wiki/Bipolar_transistor_biasing

    Emitter bias. When a split supply (dual power supply) is available, this biasing circuit is the most effective. It provides zero bias voltage at the emitter or collector for load. [clarification needed] The negative supply V ee is used to forward-bias the emitter junction through R e. The positive supply V cc is used to reverse-bias the ...

  3. Emitter-coupled logic - Wikipedia

    en.wikipedia.org/wiki/Emitter-coupled_logic

    Note the Q5 and Q6 emitters coupled to the output. In electronics, emitter-coupled logic ( ECL ) is a high-speed integrated circuit bipolar transistor logic family . ECL uses an overdriven bipolar junction transistor (BJT) differential amplifier with single-ended input and limited emitter current to avoid the saturated (fully on) region of ...

  4. Common emitter - Wikipedia

    en.wikipedia.org/wiki/Common_emitter

    A typical example of the use of a common-emitter amplifier is shown in Figure 3. Figure 3: Single-ended npn common-emitter amplifier with emitter degeneration. The AC-coupled circuit acts as a level-shifter amplifier. Here, the base–emitter voltage drop is assumed to be 0.65 volts.

  5. Bipolar junction transistor - Wikipedia

    en.wikipedia.org/wiki/Bipolar_junction_transistor

    The collector–emitter current can be viewed as being controlled by the base–emitter current (current control), or by the base–emitter voltage (voltage control). These views are related by the current–voltage relation of the base–emitter junction, which is the usual exponential current–voltage curve of a p–n junction (diode).

  6. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  7. Open collector - Wikipedia

    en.wikipedia.org/wiki/Open_collector

    For an NPN open emitter output, the collector is connected to the positive voltage rail, so the emitter outputs a high voltage when the transistor is on and is hi-Z when off. For a PNP open emitter output, the collector is connected to the low voltage supply, so the emitter outputs a low voltage when the transistor is on and is hi-Z when off.

  8. Iowa water utilities notifying thousands of homeowners they ...

    www.aol.com/iowa-water-utilities-notifying...

    The diagram shows the typical location of a lead service line, which runs from a residence's water meter to the Des Moines Water Works water main. Lead pipes are more likely to be found in older ...

  9. Egg prices have risen steadily over the past two years. A spike in avian flu and the approaching holiday season are combining to make the problem even worse.