Search results
Results from the WOW.Com Content Network
The M-1956 LCE continued application of the belt-supported-by-suspenders concept, adopted by the U.S. Army at least as early as the pattern 1903 equipment. [2] The M-1956 "Belt, Individual Equipment" or pistol belt differed little in form and function from the M-1936 pistol belt and would accommodate any of the pouches and equipment that would mount on the M-1936 belt.
An ammunition belt is a firearm device used to package and feed cartridges, typically for rapid-firing automatic weapons such as machine guns. Belt-fed systems minimize the proportional weight of the ammunition apparatus to the entire weapon system, and allow high rates of continuous fire without needing frequent magazine changes.
In western movies, the characters' gun belts are often worn low on the hip and outer thigh, with the holster cut away around the pistol's trigger and grip for a smooth, fast draw. This type of holster is a Hollywood anachronism. [5] Fast-draw artists can be distinguished from other movie cowboys because their guns will often be tied to their thigh.
The medium size individual equipment belt (NSN 8465-00-001-6488) is for soldiers with waists measuring under 30 inches (76 cm) and size large (NSN 8465-00-001-6487) is for those with waists measuring 30 inches (76 cm) or over. The length of the belt is adjusted at each end by means of adjusting clamps which slide along the belt when opened. [3]
The M13 link replaced the older M1 links designed for .30-06 Springfield ammunition, which bound cartridges to each other at the neck, used on the older M1917 Browning machine gun and M1919 Browning machine gun family, though some conversions of the M1919 to the M13 were done, such as on the U.S. Navy Mark 21 Mod 0 machine gun, which saw service in the Vietnam War.
This is in contrast with older belt systems which were typically made of fabric and were fed straight through the weapon without disintegrating. MIL-L-63532C stipulates that the force to strip a NATO approved round from the M27 link should be between 5.5 and 16 lb f (24.5 and 71.2 N ) and the belt should have a minimal tensile strength of 33 lb ...
Flatau envisioned mounting the item on a belt or a saddle. A modified hammer screw with a large head that protruded 3/4" from the frame would be installed on the Colt. This screw head would be inserted into the rig and held in place via a strip of spring steel that was attached to the gun belt via rivets.
Pages in category "Guns of the American West" The following 83 pages are in this category, out of 83 total. This list may not reflect recent changes. 0–9.