Ads
related to: toto water closet flush valveebay.com has been visited by 1M+ users in the past month
build.com has been visited by 100K+ users in the past month
Excellent Customer Service & On-time Shipping - Bizrate
homedepot.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A typical flush toilet is a fixed, vitreous ceramic bowl (also known as a pan) which is connected to a drain. After use, the bowl is emptied and cleaned by the rapid flow of water into the bowl. This flush may flow from a dedicated tank (cistern), a high-pressure water pipe controlled by a flush valve, or by manually pouring water into the bowl.
A dual flush toilet; note the two buttons at the top of the cistern. A dual flush toilet is a variation of the flush toilet that uses two buttons or a handle mechanism to flush different amounts of water. The purpose of this mechanism is to reduce the volume of water used to flush different types of waste.
The mechanism of a flushing trough: pulling the flush chain (1) rocks the flush lever (2) and lifts the siphon plate (3), forcing water over the top of the siphon (4) and starting the flush. Water is sucked through a connecting pipe (5) from the timing box (6) and air enters the timing bottle through the vent pipe (7) until the box is empty and ...
When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.
The valve is shut off at both its top and bottom positions. A second valve, placed within the main cylinder valve, releases the water in the topmost pressure chamber when the flush lever is activated, sending the main cylinder valve shooting upwards. The topmost pressure chamber slowly refills through its narrow passageway, pushing the valve ...
Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.