Search results
Results from the WOW.Com Content Network
Parts of a sewing machine needle and comparison of several types of needle points and parts. A sewing machine needle is a specialized needle for use in a sewing machine. A sewing machine needle consists of: [1] shank - clamped by the sewing machine's needle holder; shoulder - where the thick shank tapers down to the shaft
A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
Robertson screwdrivers are easy to use one-handed, because the tapered socket tends to retain the screw, even if it is shaken. [3]: 85–86 They also allow the use of angled screwdrivers and trim-head screws. The socket-headed Robertson screws are self-centering and reduce cam out. They also stop a power tool when set, and can be more easily ...
In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...
In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...
A standard metric (concrete) block is 190 mm wide, 390 mm long, and 190 mm high, which allows for 10 mm mortar joints in between bricks, giving a standard unit size of 200 mm square by 400 mm long. [3] A standard metric brick is 90 by 57 by 190 mm; with 10 mm of mortar, that produces a standard unit of 100 mm x 200 mm. [3]
Needles with their size in mm. In the UK, the metric system is used. Previously, needles 'numbers' were the Standard Wire Gauge designation of the wire from which metal needles were made. The origin of the numbering system is uncertain but it is thought that needle numbers were based on the number of increasingly fine dies that the wire had to ...
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...