Search results
Results from the WOW.Com Content Network
A simple serial interface loopback test, called paperclip test, is sometimes used to identify serial ports of a computer and verify operation. It utilizes a terminal emulator application to send characters, with flow control set to off, to the serial port and receive the same back.
Most of the interchange circuits are Category I, with the exception of Local Loopback (pin 18), Remote Loopback (pin 21), and Test Mode (pin 25) being Category II. TIA-530 originally used Category I circuits for what is commonly called "Data Set Ready" (DCE Ready, pins 6 and 22) and "Data Terminal Ready" (DTE Ready, pins 20 and 23).
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.
A null modem adapter. Null modem is a communication method to directly connect two DTEs (computer, terminal, printer, etc.) using an RS-232 serial cable.The name stems from the historical use of RS-232 cables to connect two teleprinter devices or two modems in order to communicate with one another; null modem communication refers to using a crossed-over RS-232 cable to connect the teleprinters ...
Frequent use of a serial port is for a direct computer-to-computer connection. This requires an adapter called a null modem, which isn't actually a modem in the traditional sense, but rather a connector plug that simply crosses the complementary pins on two serial ports so the two sides can communicate. A null modem typically connects the DTR ...
JTAG is specifically intended to provide reliable test access to the I/O pins from an off-board controller with less precise signal delay and skew parameters, while SPI has many varied applications. While not strictly a level sensitive interface, the JTAG protocol supports the recovery of both setup and hold violations between JTAG devices by ...
A software-based virtual serial port presents one or more virtual serial port identifiers on a PC which other applications can see and interact with as if they were real hardware ports, but the data sent and received to these virtual devices is handled by software that manipulates the transmitted and received data to grant greater functionality.
T1000-37 Tesuto Breakout box employing commonly used 37 position D-sub connectors that break out to banana jack test points. A four-port serial (RS-232) PCI Express ×1 expansion card with an octopus cable that breaks the card's DC-37 connector into four standard DE-9 connectors Example of a pocket-sized RS-232 breakout box that features switches to reconfigure or patch any or all the active ...