Search results
Results from the WOW.Com Content Network
Each capacitor sensor consists of two metal rings mounted on the circuit board at some distance from the top of the access tube. These rings are a pair of electrodes, which form the plates of the capacitor with the soil acting as the dielectric in between. The plates are connected to an oscillator, consisting of an inductor and a capacitor. The ...
Mutual capacitive sensors have a capacitor at each intersection of each row and each column. A 12-by-16 array, for example, would have 192 independent capacitors. A voltage is applied to the rows or columns. Bringing a finger or conductive stylus near the surface of the sensor changes the local electric field which reduces the mutual capacitance.
Capacitive displacement sensors can be used to measure the position of objects down to the nanometer level. This type of precise positioning is used in the semiconductor industry where silicon wafers need to be positioned for exposure. Capacitive sensors are also used to pre-focus the electron microscopes used in testing and examining the wafers.
In a CCD image sensor, pixels are represented by p-doped metal–oxide–semiconductor (MOS) capacitors.These MOS capacitors, the basic building blocks of a CCD, [1] are biased above the threshold for inversion when image acquisition begins, allowing the conversion of incoming photons into electron charges at the semiconductor-oxide interface; the CCD is then used to read out these charges.
A force-sensing capacitor is a material whose capacitance changes when a force, pressure or mechanical stress is applied. They are also known as "force-sensitive capacitors". They can provide improved sensitivity and repeatability compared to force-sensitive resistors [1] but traditionally required more complicated electroni
A multimeter in a resistance range can detect a short-circuited capacitor (very low resistance) or one with very high leakage (high resistance, but lower than it should be; an ideal capacitor has infinite DC resistance). A crude idea of the capacitance can be derived with an analog multimeter in a high resistance range by observing the needle ...
An ideal capacitor is characterized by a constant capacitance C, in farads in the SI system of units, defined as the ratio of the positive or negative charge Q on each conductor to the voltage V between them: [23] = A capacitance of one farad (F) means that one coulomb of charge on each conductor causes a voltage of one volt across the device. [25]
The start capacitor is typically mounted to the side of the motor housing. These are called capacitor-start motors, and have relatively high starting torque. There are also capacitor-run induction motors which have a permanently connected phase-shifting capacitor in series with a second winding. The motor is much like a two-phase induction motor.