enow.com Web Search

  1. Ads

    related to: small sheet metal rolling machine

Search results

  1. Results from the WOW.Com Content Network
  2. Rolling (metalworking) - Wikipedia

    en.wikipedia.org/wiki/Rolling_(metalworking)

    For thin sheet metal with a thickness less than 200 μm (0.0079 in), [citation needed] the rolling is done in a cluster mill because the small thickness requires a small diameter rolls. [10] To reduce the need for small rolls pack rolling is used, which rolls multiple sheets together to increase the effective starting thickness.

  3. Plate rolling machine - Wikipedia

    en.wikipedia.org/wiki/Plate_rolling_machine

    It can be also called a “roll bending machine”, “plate bending machine” or “rolling machine”. There are different kinds of technology to roll the metal plate: Four-roller machines have a top roll, the pinching roll, and two side rolls. The flat metal plate is placed in the machine on either side and "pre-bent" on the same side.

  4. Z-Mill - Wikipedia

    en.wikipedia.org/wiki/Z-mill

    The Z-Mill or Sendzimir Mill is a machine for rolling steels. [1] [2] Unlike a traditional rolling mill this 20-high cluster mill configuration utilizes cascaded supporting rolls to apply force on the small work rolls in the center. This allows the application of a higher roll pressure without bending the work rolls, which would result in poor ...

  5. Tandem rolling mill - Wikipedia

    en.wikipedia.org/wiki/Tandem_rolling_mill

    A tandem rolling mill is a rolling mill used to produce wire and sheet metal. It is composed of two or more close-coupled [clarification needed] stands, and uses tension between the stands as well as compressive force from work rolls [clarification needed] to reduce the thickness of steel. It was first patented by Richard Ford in 1766 in England.

  6. Roll forming - Wikipedia

    en.wikipedia.org/wiki/Roll_forming

    Roll forming, also spelled roll-forming or rollforming, is a type of rolling involving the continuous bending of a long strip of sheet metal (typically coiled steel) into a desired cross-section. The strip passes through sets of rolls mounted on consecutive stands, each set performing only an incremental part of the bend, until the desired ...

  7. English wheel - Wikipedia

    en.wikipedia.org/wiki/English_wheel

    The operator of the machine passes the sheet metal between the anvil wheel and the rolling wheel. This process stretches the material and causes it to become thinner. As the material stretches, it forms a convex surface over the anvil wheel. [1] This surface is known as "crown".

  1. Ads

    related to: small sheet metal rolling machine